2003 Dodge 1500 Hemi remote start

Home / the12volt's Install Bay / Car Security and Convenience / 2003 Dodge 1500 Hemi remote start (

Topic Closed)

Welcome Guest :)

Members

Next Page > < Prev Topic Next Topic >

Slcoo3

Member - Posts: 8

Joined: December 17, 2003

Location: United States

Posted: December 17, 2003 at 5:18 PM / IP Logged

I'm looking for the wiring diagram for the 2003 Hemi. Can any one help?

Geeque

Silver - Posts: 310

Joined: October 07, 2003

Location: United States

Posted: December 17, 2003 at 5:28 PM / IP Logged

2 dr or ext cab?

Gary Kline

MECP Master Technician

Slcoo3

Member - Posts: 8

Joined: December 17, 2003

Location: United States

Posted: December 17, 2003 at 5:35 PM / IP Logged

The trucks a 2 dr.

Geeque

Silver - Posts: 310

Joined: October 07, 2003

Location: United States

Posted: December 17, 2003 at 6:15 PM / IP Logged

Dodge

Ram Pickup

2002-2004

Remote Starter Wiring Colors and Notes
Function	Vehicle Color	Location
Start:	YELLOW	IGNITION SWITCH HARNESS
Ignition #1:	BLUE (16 AWG)	IGNITION SWITCH HARNESS
Ignition #2:	RED	IGNITION SWITCH HARNESS
Ignition #3:	GREEN & ORANGE (2 WIRES)	IGNITION SWITCH HARNESS
Accessory:	BLACK/ WHITE & BLUE (2 WIRES)	IGNITION SWITCH HARNESS
Brake Light:	WHITE/ TAN	AT SWITCH ABOVE BRAKE PEDAL
Tach Signal:	TAN/RED	AT IGNITION COIL
Parking Lights:	PURPLE / YELLOW	HEADLIGHT SWITCH*
Headlights:	PURPLE / YELLOW	HEADLIGHT SWITCH *
OEM Alarm Disarm:	LT. GREEN/ ORANGE *****	HARNESS COMING IN FROM DRIVER'S DOOR
OEM Alarm Arm:
Diesel Glow Plug:	ORANGE / Black	Powertrain Control Module***
Clutch Bypass Wire:
Notes:	* This Is A Single Wire System. Parking Lights Need To See A Ground (-) Through A 330 Ohm Resistor. Headlights Need To See A Ground (-) Through A 700 Ohm Resistor. Diesel Vehicles - ORANGE / Black Wait to Start; Tach Wire Is Gray/Black. Both Wires Are Located In A Black Connector Center Top Of Fire Wall. There Are Two Black Connectors, The Correct One Does Not Have A White Insert. * Tach can also be located at pin 74 behind instrument cluster.

Dodge

Ram Pickup

2002-2004

Alarm and Keyless Entry Wiring Colors and Notes
Function	Vehicle Color	Location
Constant +12 Volts:	PINK/BLACK	IGNITION SWITCH HARNESS
Starter Kill:	YELLOW	IGNITION SWITCH HARNESS
Ignition +12 Volts:	BLUE (16 AWG)	IGNITION SWITCH HARNESS
Dome Lights/Superv:	SEE NOTE ***
OEM Horn:	BLACK/ RED (-)	STEERING COLUMN HARNESS
Power Lock:	WHITE/ GREEN	DRIVER'S KICK PANEL ****
Power Unlock:	WHITE/ GREEN	DRIVER'S KICK PANEL ****
Trunk Release:	N/A
Alarm Input Wire:	SEE NOTE ***
Notes:	* Separate Triggers For Each Door. The Driver's Door Trigger Is Tan (-). The Left Rear Door Trigger Is Tan/Orange (-). Both Wires Can Be Found In The Driver's Kick Panel. The Passenger Front Door Trigger Is Tan/Red (-) And the Passenger Rear Door Trigger Is Tan / YELLOW (-). Both Of These Wires Can Be Found In The Passenger Kick Panel. Diode Isolate Each Wire For Alarm Trigger With The Bands Facing Away From The Alarm/Remote Start Module. Use Only One Trigger For Dome Light Supervision. Single Wire Door Lock System See Note #211. Lock Requires A Ground (-) Pulse Through A 867 Ohm Resistor. Unlock Requires A Ground (-) Pulse Through A 364 Ohm Resistor. Diode Isolate One Of The Wires. *** Requires A Negative Pulse Through A 1.5 K-Ohm Resistor.

DesignTech International, Inc.

Tel: (703) 866-2000 Fax: (703) 866-2001

7955 Cameron Brown Court

Springfield, Virginia 22153 USA

1-800-DESIGNTECH

(1-800-337-4468)

DesignTech International, Inc.

www.designtech-intl.com

DesignTech disclaims any liability or responsibility arising out of any inaccuracies of this information or use of this

information for installations or otherwise. Please verify all wiring for accuracy prior to making any connections.

Gary Kline

MECP Master Technician

Geeque

Silver - Posts: 310

Joined: October 07, 2003

Location: United States

Posted: December 17, 2003 at 7:03 PM / IP Logged

Should be the same.

Gary Kline

MECP Master Technician

auex

Platinum - Posts: 5,041

This member has made a donation to the12volt.com. Click here for more info.

Joined: December 23, 2002

Location: Arizona, United States

Posted: December 17, 2003 at 7:13 PM / IP Logged

Hey Geeque, as far as posting your designtech diagram's, you may want to delete the bottom portion of the diagram.

Certified Security Specialist

Always check info with a digital multimeter.

I promise to be good.

Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

Geeque

Silver - Posts: 310

Joined: October 07, 2003

Location: United States

Posted: December 17, 2003 at 7:15 PM / IP Logged

Thanks just trying to help!

Gary Kline

MECP Master Technician

Geeque

Silver - Posts: 310

Joined: October 07, 2003

Location: United States

Posted: December 17, 2003 at 7:16 PM / IP Logged

Let them sue me!!!!

Gary Kline

MECP Master Technician

securinu

Silver - Posts: 772

Joined: September 15, 2002

Location: United States

Posted: December 17, 2003 at 10:50 PM / IP Logged

Also the 2004 is completely different All new colors. 02 and 03 are the same

Joe O'Byrne

Owner / Installer

Slcoo3

Member - Posts: 8

Joined: December 17, 2003

Location: United States

Posted: December 25, 2003 at 1:09 PM / IP Logged

Will I need an immobilizer ?

Next Page >

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.