1999 f150 compustar remote start

Home / the12volt's Install Bay / Car Security and Convenience / 1999 f150 compustar remote start (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

j blakey

Member - Posts: 4

Joined: December 25, 2003

Location: Canada

Posted: December 26, 2003 at 12:29 PM / IP Logged

recently installed in 1999 f150, can't get it to crank over

jiminee

Back to Top

jrilla

Gold - Posts: 1,498

This member has made a donation to the12volt.com. Click here for more info.

Joined: November 19, 2002

Location: North Dakota, United States

Posted: December 26, 2003 at 4:19 PM / IP Logged

Did you install a transponder bypass: either universal that requires the use of an additional programmed ignition key, or a no key required module. If you have not, then try putting the key in the ignition but do not turn it and then remote start. If it works then you just need to install a bypass. If it still does not work then you will also need to do something else.

Please provide all the information you have too.

J Rilla

Owner/Installer

Back to Top

j blakey

Member - Posts: 4

Joined: December 25, 2003

Location: Canada

Posted: December 26, 2003 at 10:43 PM / IP Logged

i have installed a transponder by pass, i have also tried to start with the key in and got no results. i pulled a wire identification chart off the net, i am assuming it is correct., it the one bulldog security publishes with their remote start. Thanks

jiminee

Back to Top

jihadhi

Member - Posts: 4

Joined: January 23, 2003

Location: United States

Posted: January 08, 2004 at 7:55 PM / IP Logged

As long as you installed it correctly, you have to actually program/turn on the alarm and program the buttons to the alarm.

Back to Top

j blakey

Member - Posts: 4

Joined: December 25, 2003

Location: Canada

Posted: January 08, 2004 at 8:16 PM / IP Logged

I am assuming it is installed correctly, i went through programing mode described in the manual. I begining to wonder if its a dud thanks

jiminee

Back to Top

Brad Eyben

Member - Posts: 33

Joined: January 28, 2003

Location: Canada

Posted: January 08, 2004 at 8:55 PM / IP Logged

What model of compustar? 2way? alarm?

Is your hood closed?

Are you holding the start button for a full 2 seconds?

What happens when you push the start button? Beeps? Display?

Brad

Back to Top

j blakey

Member - Posts: 4

Joined: December 25, 2003

Location: Canada

Posted: January 08, 2004 at 10:46 PM / IP Logged

Its a CM 4200, The hood is closed, I,m quite sure the start button was held for 2 seconds , but i will check that. When the start button is pushed the light on the remote flashes and a light on the antenna also flashes. The same thing happens with door locks. It does seem to be a programing problem.

Thanks

jiminee

Back to Top

misterjimbo

Silver - Posts: 535

Joined: October 11, 2003

Location: Michigan, United States

Posted: January 08, 2004 at 10:50 PM / IP Logged

does the theft light in the dash glow steady for 3 to 4 seconds or does it flash fast when you try to remote start

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

1999 f150 compustar remote start

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.