the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

95 cavalier ignition coil


Post ReplyPost New Topic
< Prev Topic Next Topic >
hubbabubbamac 
Member - Posts: 27
Member spacespace
Joined: September 09, 2003
Posted: December 30, 2003 at 10:15 AM / IP Logged  
hey i just need to know because i cannot seem to find it.........where is the ignition coil/system in my 95 cavalier (2.2)
sparkie 
Platinum - Posts: 2,061
Platinum spacespace
Joined: November 06, 2003
Location: Canada
Posted: December 30, 2003 at 8:21 PM / IP Logged  
It's on the back side of the engine. It is near the firewall and down low on the motor. It's a real pain to get to.
sparky
hubbabubbamac 
Member - Posts: 27
Member spacespace
Joined: September 09, 2003
Posted: December 30, 2003 at 9:28 PM / IP Logged  

and then that is wehre i would hook up my tach signal wire to right

mikeshonda750 
Copper - Posts: 105
Copper spacespace
Joined: December 03, 2003
Location: United States
Posted: December 30, 2003 at 9:39 PM / IP Logged  
2.2 and 2.4L 96 Cavalier ... WHITE wire at the PCM (Powertrain Controll Module) usually mounted on the firewall either side of the engine... sometimes mounted up near the battery.. sometimes opposite side of the car from the battery... usually identified by the large plug into the box with a bolt holding it together... about the biggest mass of wires under the hood you can find...  TIP: Trace the large wire loom from the PCM/ECM over as close as possible to where you went through the firewall, but still have room to tear into it and splice away... cut off excess wire and solder your connection in and tape er up
sparkie 
Platinum - Posts: 2,061
Platinum spacespace
Joined: November 06, 2003
Location: Canada
Posted: December 31, 2003 at 4:48 PM / IP Logged  
The easiest place to obtain the tach wire is inside the split tube looming running front to back on the driver's side of the motor overtop of the transmission. If you in this harness it heads to the back part of the motor. There is only one white wire in the harness and that is the tach wire for the vehicle. The engine computer is under the passenger's front fender ahead of the tire and is only accessible from underneath the vehicle. Going to the harness I described is easy and allows enough room to make a good connection with solder. For a good ignition source use the thick pink wire under the driver's side dash in the harness coming from the steering column/ignition switch.
sparky

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Wednesday, May 15, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer