2004 chevy tahoe, alarm/remote start

I'm looking for a wiring diagram for a chevy 2004 tahoe for the locks and to remote start.I also have a Crime Stopper GMLK-U for the locks and it has a 4 pin connector that needs to be plugged into the doorlock port of the omega host system. Where is it located and what does it look like. Is there a way to tie the heated seats in so they would work also .Thanks

Looking for a wiring diagram for a chevy 2004 tahoe to install a remote start system. thanks      

Your going to need a door lock interface module. everything runs on the data bus wire. 12+ - Red Ign - Ign 2nd Ign - white Starter wire - yellow Acc - orange 2nd Acc - brownDJ,Scottsdale Extreme Sound

I have a 2004 Tahoe with a crimestopper PLDATA II in it. I have to arm the truck with the remote starter before it will let me begin to remote start the truck.If I arm the truck and remote start the truck right away everything is fine. If I arm the truck wait 1 minunite or longer and then remote start the factory alarm goes off.Any ideas.   thanks

That kit from crime stopper should disarm and arm for you in addition to locking and unlocking. I find it wierd that you would need to arm the truck before remote starting. Typically you would need to disarm. There is a disarm wire in the door though. It is lt.green.J Rilla

Owner/Installer

It's the remote starter that requires me to arm before starting.Which in turn arms the factory alarm threw the PLDATA II. So after arming and waiting 1 minute or longer is where the proplem is.