Auto. door UNLOCK

Home / the12volt's Install Bay / Relays / Auto. door UNLOCK (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

johnnyb_s

Member - Posts: 2

Joined: August 04, 2002

Posted: August 04, 2002 at 2:16 PM / IP Logged

How does this configuration work?: https://www.the12volt.com/doorlocks/page3.asp#aul

I tried wiring it up, just as stated in the link, but I can't get it to work. Also, where is the ground for the coil to engage?

Thanks for your help!

Back to Top

johnnyb_s

Member - Posts: 2

Joined: August 04, 2002

Posted: August 07, 2002 at 7:20 AM / IP Logged

^bump^

Back to Top

2000vsm

Copper - Posts: 65

Joined: June 30, 2002

Posted: August 07, 2002 at 10:38 PM / IP Logged

when ign is off it acts as a ground due to all the internal connections....

if it doesn't work you probably should change the resistor value lower.. 1000uf is ok.. try 2000uf or higher and use like a 1000ohm resisotr... reason is if you use like a 500000 ohm, it'll take like 5 mintues before the cap will drain therefore not going to activate the coil...

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Auto. door UNLOCK

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.