Tach wire is damaged on Honda accord 1998

Home / the12volt's Install Bay / Car Security and Convenience / Tach wire is damaged on Honda accord 1998 (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

nguyen

Member - Posts: 22

Joined: September 05, 2002

Location: United States

Posted: January 27, 2004 at 11:13 AM / IP Logged

I test a tach wire on Honda accord 1998, show 4-5volt AC when engine run. It is blue wire at 2pin test connector near the battery.

Some how after 5 minute volt meter show o volt when engine run or stop. When I start a car by key the light "require maintains" is plashing, the remote commando 5005 can’t learn this tach wire

What should I do if A tach wire is damaged ?

Nguyen

boomer_106

Silver - Posts: 710

Joined: November 25, 2003

Location: United States

Posted: January 27, 2004 at 3:01 PM / IP Logged

Honda

Accord

1998-2002

Remote Starter Wiring Colors and Notes
Function	Vehicle Color	Location
Start:	BLACK/ WHITE	IGNITION SWITCH HARNESS **
Ignition #1:	BLACK / YELLOW	IGNITION SWITCH HARNESS
Ignition #2:	YELLOW	IGNITION SWITCH HARNESS
Ignition #3:
Accessory:	WHITE/ BLACK	IGNITION SWITCH HARNESS
Brake Light:	WHITE/ BLACK	AT SWITCH ABOVE BRAKE PEDAL
Tach Signal:	BLUE	AT COIL MODULE
Parking Lights:	RED / BLACK	AT FUSE BLOCK ON DRIVER'S SIDE
Headlights:
OEM Alarm Disarm:	BLUE	INSIDE OF DRIVER'S DOOR
OEM Alarm Arm:	BLUE/WHITE	INSIDE OF DRIVER'S DOOR
Diesel Glow Plug:
Clutch Bypass Wire:
Notes:	* This vehicle is equipped with a transponder immobilizer system; See Installation Note #144 - Bypassing Transponder Theft Systems.

Teamrf

Gold - Posts: 1,031

Joined: January 13, 2004

Location: United States

Posted: January 28, 2004 at 12:09 AM / IP Logged

Well I'm not too sure about those alarms but if it has a "voltage sense" you can just program it to start from voltage. A lot of installers use voltage in the first place.

~The Rookie~

Rookie of the year that is...

Don't let the smoke out of your equiptment..it doesn't go back in.

jimmeezgolfvr6

Silver - Posts: 258

Joined: March 10, 2002

Location: Canada

Posted: January 28, 2004 at 5:45 AM / IP Logged

a good alternative is using one of the fuel injector wires. each fuel injector should have 2 wires to it, and there will be a same coloured wire amongst all of them....use one of the wires that is different coloured.

good luck

Search for other posts by jimmeezgolfvr6

daniel2002p

Silver - Posts: 524

Joined: October 10, 2003

Location: United States

Posted: January 29, 2004 at 9:11 PM / IP Logged

go with the odd coloured wire at the injectors.

2005 Toyota Corolla S

1.8L VVT-i I-4

Always double check your wires with a DMM!!!

Do Not Use A Test Light!!!

MECP Certified Installer!

Best Buy 665 - IN IT TO WIN IT! TEAM MOBLE!

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Tach wire is damaged on Honda accord 1998

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.