2003 PT Cruiser Dome Light

Home / the12volt's Install Bay / Car Security and Convenience / 2003 PT Cruiser Dome Light (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

FredA1974

Copper - Posts: 31

Joined: July 04, 2003

Location: United States

Posted: February 04, 2004 at 9:31 PM / IP Logged

I have installed a Honet (DEI) Remote Start/Alarm. I have noticed that after the remote start remotely turns off after 12 mins. the alarm goes off. I believe it doing this because I did not hook up the dome light supervision from the alarm. I had a hard time finding the door trigger wire so I did not bother looking for this wire since everything I read said there was 3 different wires and I had none of them. I did find 1 yellow wire in the pass. kick panel that worked with all the doors and hatch. I was wonding if this wire will control my dome light supervision. Also if this is the cause of the alarm going off after the remote start turns off.

If anyone can fill me in that would be great. Also can I remove the factory brain? We I disconnected it nothing in the car worked. If it is not possible then no biggy but every once in a while it activates and I have to use the factory remote to turn it off. Thanks for all your help.

Teamrf

Gold - Posts: 1,031

Joined: January 13, 2004

Location: United States

Posted: February 04, 2004 at 9:51 PM / IP Logged

You may want to put a diode on that wire. So it wouldn't kick back to the alarm. But other than that you shouldn't have a problem with your alarm going off.

~The Rookie~

Rookie of the year that is...

Don't let the smoke out of your equiptment..it doesn't go back in.

FredA1974

Copper - Posts: 31

Joined: July 04, 2003

Location: United States

Posted: February 04, 2004 at 11:26 PM / IP Logged

Diode on what wire? Is the yellow wire I am using the right wire I should be using for the door trigger? And is it ok to hook the dome light supervision to it (I have not yet done)?

bmf1000d

Silver - Posts: 345

Joined: September 30, 2003

Location: United States

Posted: February 05, 2004 at 9:00 AM / IP Logged

Dome Lights/Superv:

Tan & Tan/Blue (-)

Keyless module above radio

Must diode isolate. Tan wire is the door trigger for the Drivers door and the Tan/Blue is for all other doors.

you dont need to disconnect the factory unit just leave it in there cause more than alrm wiring runs through there.

"Big" Mike

Double Take

Fremont, Ne

remember to check all your wires with a dmm not a test light!!

i take no responsibilty whatsoever for the vailidty of the info nor consequences thereof

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

2003 PT Cruiser Dome Light

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.