Toyota Rav4 install help?

Try neg. pulse at intergration relay under drivers dash. lock...blue/wht un-lock...blue/yell.

and dont forget the blue wire its the child safty wire. also i have seen the rav 4 have 2 lock wires and onl one unlock

What is it I need to do with the child saftey wire? And if it has 2 lock wires would I then connect the 1 alarm wire to both factory lock wires? Thanks, Greg

listen there is a relay under the dash on the drivers side if you lock the doors with the switch u will hear this click!!!!That is where u wanna be, the wire colors are blue/white for lock and blue / YELLOW for unlock these are negative triggered so use the negative output for the doors locks! If it had a child safety then u will need a diode and face the band towards the alarm on the unlock wire and the other side of the diode will go to a blue wire that is how u do child safety! The child safety wire gets pulsed ground when the unlock switch is pressed or when the key is turned in the passenger door i believe. I would try not to get the child safety wire u may not need to!!

And i also think in the owners manual it tells u how to turn child safety off !!

Thanks Man, I'll give that another try. I just thought I was really missing something by not getting the lock feature to work. And I never heard anything about the child saftey wire before, Thanks Again, Greg

listen gc714 you dont need the child safety wire to make the door locks work,just hook up the 2 wires i told you and that is all!!! u may not need th echild safety wire hooked up and i told you there is a way of turning that feature off! If you dont have kids u dont need it!! Last thing if the door lock wires off the alarm cannot work the locks with th ewires i told you then it may need a stronger ground to do this would require 2 relays but i dought this ,just letting you know! If you need anything else pm me or post back here. good luck