98 Dakota Power Door Locks

Home / the12volt's Install Bay / Car Security and Convenience / 98 Dakota Power Door Locks (

Topic Closed)

Welcome Guest :)

Members

Next Page > < Prev Topic Next Topic >

robbain

Member - Posts: 23

Joined: February 14, 2004

Posted: February 25, 2004 at 11:17 AM / IP Logged

I'm installing a Crimestopper CS2015FM TW1 in my 1998 Dakota. I'm trying to figure out how to hook up the power door locks. I think they are reverse polarity and require extra relays. Any help or diagrams would be greatly appreciated. Thanks.

Rob

robbain

Member - Posts: 23

Joined: February 14, 2004

Posted: February 25, 2004 at 11:21 AM / IP Logged

Also, the vehicle has factory power locks but no keyless entry. Thanks.

Rob

draasch

Gold - Posts: 2,172

Joined: February 07, 2003

Location: Florida, United States

Posted: February 25, 2004 at 12:20 PM / IP Logged

what are the outputs on the alarm????

Power Lock ORN/PPL OR GRN/BLK 16 PIN CONNECTOR BEHIND ** #203

Power Unlock PINK/VIOLET FUSE BLOCK IN DRIVER KICK PANEL

203 - See Reversal Rest At Ground Door Lock Diagram W/Or WO Keyless.

http://wiringinstructions.com/203.htm

Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

davedyer79

Copper - Posts: 178

Joined: February 18, 2004

Location: United States

Posted: February 25, 2004 at 12:31 PM / IP Logged

A little easier wiring diagram. The diagram that draasch sent is for a DLS plug from Omega, which would make the connections a lot easier. If you do not have the DLS, grab two SPDT relays from the automotive store or Circuit City and wire the like this diagram

https://www.the12volt.com/doorlocks/page3.asp#5w

This will work if the outputs of your alarm is negative outputs, which it should be.

Good luck.

davedyer79

Sandungero24

Member - Posts: 44

Joined: February 24, 2004

Location: United States

Posted: February 26, 2004 at 3:32 PM / IP Logged

( 1998 Dodge Dakota Alarm Information )

robbain

Member - Posts: 23

Joined: February 14, 2004

Posted: February 26, 2004 at 3:59 PM / IP Logged

Another thing I noticed on the wiring diagram was that it lists BLACK/ orage for accessory and for ignition 2. Does this mean there are two BLACK/ orage wires? or do I just use it for the accessory and there is no ignition 2? Thanks.

Rob

draasch

Gold - Posts: 2,172

Joined: February 07, 2003

Location: Florida, United States

Posted: February 26, 2004 at 4:05 PM / IP Logged

Remote Start

Tach Signal BLACK/ GRAY AT IGNITION COIL *

Ignition #2 BLACK/ ORANGE IGNITION SWITCH HARNESS (HEAT/AC)

Ignition #3 N/A

Accessory BLACK/ WHITE IGNITION SWITCH HARNESS

Neutral Safety BLACK/ WHITE (-) AT POWERTRAIN CONTROL MODULE **

Brake Light WHITE/ TAN (+) AT SWITCH ABOVE BRAKE PEDAL

Reverse Light VIOLET/BLACK (+) AT SWITCH ON TRANSMISSION

Rear Window Defrost N/A

* Ignition Coil Is Located On Passenger Front Of Engine. BLACK/ GRAY Wire Is Also Located At Powertrain Control Module (PCM) In A Black 32 Pin Connector. ** Powertrain Control Module (PCM) Is Located On Passenger Rear Of Engine Next To Strut Tower.

Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

daniel2002p

Silver - Posts: 524

Joined: October 10, 2003

Location: United States

Posted: February 26, 2004 at 8:00 PM / IP Logged

your locks are reverse polarity, but BLACK/ orange is acc and lt blue is ignition.

2005 Toyota Corolla S

1.8L VVT-i I-4

Always double check your wires with a DMM!!!

Do Not Use A Test Light!!!

MECP Certified Installer!

Best Buy 665 - IN IT TO WIN IT! TEAM MOBLE!

robbain

Member - Posts: 23

Joined: February 14, 2004

Posted: February 26, 2004 at 9:30 PM / IP Logged

One person tells me that BLACK/ orange is ign 2 and somebody else says it is acc. I've been told that dk blue is ign, now it's lt blue. Who is right???

Rob 1998 Dakota

Sandungero24

Member - Posts: 44

Joined: February 24, 2004

Location: United States

Posted: February 26, 2004 at 9:32 PM / IP Logged

Ignition 1	Dark Blue	Ignition Switch Harness
Ignition 2	BLACK/ Orange	Ignition Switch Harness (Heat/AC)
Accessory	BLACK/ Orange	Ignition Switch Harness

Next Page >

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.