2001 Dakota Door pins

Just installed a alarm in my truck.  All is good but my door pin connections.  I have different pins for each door,  figured out how to diode isolate each.  The problem is that I get neg. feed when door is open, and no feed when door is closed, but about a 30 seconds later when the door is still closed it becomes negative again.  This of course trips the alarm.  I tried the dome light, but have a delayed turn of time for the dome light.  How do I get the door switches working?  Must be a wire that doesnt change state somewhere!

Dome Light YELLOW (-) AT CENTRAL TIMER MODULE * Central Timer Module Located In Drivers Kick Panel.(Dr Door TAN (-) All Others TAN/RED (-). Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

I know the wire locations and colors, but they dont work because of delayed dome light on door close and a returning negative @ the door pins.

did you make your connection at this point???? * Central Timer Module Located In Drivers Kick Panel.(Dr Door TAN (-) All Others TAN/RED (-). Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

i have never had that prob before....is there a light under the dash that you can use????? have you considered going to the domelight itself???? how about where it comes out of the CTM???Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt