2003 ford p/u

Home / the12volt's Install Bay / General Discussion / 2003 ford p/u (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

short

Member - Posts: 2

Joined: March 04, 2004

Location: United States

Posted: March 04, 2004 at 8:14 PM / IP Logged

looking for wiring diagram for ford 2003 250 p/u

mobile1

Silver - Posts: 479

Joined: February 23, 2004

Location: United States

Posted: March 04, 2004 at 8:30 PM / IP Logged

12volts	yellow & lt. GREEN/ purple	+	ignition harness
Starter	green	+	ignition harness
Second Starter	N/A
Ignition	RED / lt. green or WHITE/ yellow	+	ignition harness
Second Ignition	N/A
Third Ignition	N/A
Accessory	gray / YELLOW & RED / black	+	ignition harness
Second Accessory	blue/lt. green	+	ignition harness
Keysense
Power Lock
Power Unlock
Lock Motor	pink/black	5wi	VSM
Unlock Motor	RED / orange	5wi	VSM
Parking Lights+	brown	+	headlight switch
Parking Lights-	N/A
Hazards	same as turn signals
Turn Signal(L)	lt grn/wht (F), lt grn/org (R)	+	steering column
Turn Signal(R)	wht/lt blu (F), org/lt blu (R)	+	steering column
Reverse Light	BLACK/ pink	+	fuse box
Door Trigger	BLACK/ lt. blue	+	either kick panel
Dome Supervision	use door trigger
Trunk/Hatch Pin	N/A
Hood Pin	N/A
Trunk/Hatch Release	N/A
Power Sliding Door	N/A
Factory Alarm Arm
Factory Alarm Disarm
Disarm No Unlock
Tachometer	NOT RED / lt. green	ac	any ignition coil
Wait to start	see DirectFax document 1091
Brake Wire	lt. green	+	brake pedal switch
Parking Brake	lt. GREEN/ red	-	parking brake switch
Horn Trigger	blue	-	steering column or VSM

Without keyless entry use pink / YELLOW for lock and pink/lt. green for unlock. They are 5 wire reverse polarity mastered from the driver switch and found in either kick panel. With keyless entry use WHITE/ red for lock and BLACK/ white for unlock. They are negative trigger and found at the VSM. The VSM (Vehicle Security Module) is to the right of the accelerator pedal above the transmission hump below the radio. Not accessible from radio opening.

short

Member - Posts: 2

Joined: March 04, 2004

Location: United States

Posted: March 04, 2004 at 8:45 PM / IP Logged

thanks

i would like to know how to turn on dome light without using door tigger if possible heres the reason

alarm set, remote start car, if the car times out before i get to it the car it shuts off and the dome light comes on and sets the alarm off i figured how to get by that problem with a time delay relay but i also would like my dome light to come on when i unlock the door

NowYaKnow

Gold - Posts: 1,217

Joined: December 18, 2002

Posted: March 05, 2004 at 5:54 AM / IP Logged

Most units have a seperate wire for the door trigger and the dome supervision. Just tie your dome supervision wire in after the time delay relay to the BLACK/ blue (+) and you should be good to go.

Mike

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

2003 ford p/u

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.