2 ohms

No, a pair of these subs will hit a load of 1 ohm, 4 ohm or 16 ohms. See the other thread you started for my answer on how to wire the subs to your amp.Top Secret, I can tell you but then my wife will kill me.

wait a sec. What do u mean on a 2 channel amp? Are you going to run one sub to one channel? If thats the case, then yes, you can get it to 2 ohms, otherwise Rob is right. 1990 Honda Civic HB:

Clarion DXZ545MP H.U.

2- 6.5" Power Acoustik interiors

Diamond Audio 600.1 amp

Diamond Audio 15" M6MKII

Pyramid PB881X 4 CH. Amp

(2) 4ohm DVC's, sure you can wire them to a 2-channel amp as long as the amp is 2ohm Stereo and/or 4ohm Mono stable. You can wire 1 sub per channel by wiring each sub in Parallel for a 2ohm total load per channel. Each channel would look like this... Or you can wire the subs together in Series/Parallel for a 4ohm total load and Bridge the amp (if your 2-channel amp will accept a bridge, most do) like this... Squirrel

"No more Cpt. Kirk chit chat"

If its too loud, then you're too old

Donate to the12volt.com

Both the above diagrams above are correct.Top Secret, I can tell you but then my wife will kill me.

Both the above diagrams above are correct.Top Secret, I can tell you but then my wife will kill me.

You got itSquirrel

"No more Cpt. Kirk chit chat"

If its too loud, then you're too old

Donate to the12volt.com