Got Tips? '97 Civic Alarm Install

I plan on installing an Enforcer alarm in a '97 Civic h/b. The car has p/w, p/l, s/r, aftermarket stereo. The alarm is a few years old but never been used. Any tips, advice,  diagrams that could possibly make this install easier will be greatly appreciated.  I have experience as  auto  tech and electronics tech so no need to simplify "technical terms", just let her rip.                              Mahalo.bt

Other than the wiring diagram (below) all you need to know is Honda's are one of the easiet alarm installs out there.

Honda

Civic 1996-2000 Remote Starter Wiring Colors and Notes Function    Vehicle Color Location Start:    BLACK/ WHITE IGNITION SWITCH HARNESS Ignition #1:    BLACK / YELLOW IGNITION SWITCH HARNESS Ignition #2:    YELLOW IGNITION SWITCH HARNESS Ignition #3:    N/A Accessory:    WHITE/ BLACK IGNITION SWITCH HARNESS Brake Light:    GREEN / WHITE (+) AT SWITCH ABOVE BRAKE PEDAL Tach Signal:    BLUE AT TACH TEST CONNECTOR * Parking Lights:    RED / BLACK (+) 7 PIN GRAY CONN. AT FUSE BLOCK Headlights:    RED (+) AT HEADLIGHT SWITCH OEM Alarm Disarm:    N/A IN SCHEMATICS OEM Alarm Arm:    N/A NO OEM ALARM PRESENT Diesel Glow Plug:     Clutch Bypass Wire:     Notes:    * Tach Test Connector Is A 2 Pin WHITE Connector Located On Driver Rear Of Engine Compartment. -------------------------------------------------------------------------------- Honda Civic 1996-2000 Alarm and Keyless Entry Wiring Colors and Notes Function    Vehicle Color Location Constant +12 Volts:    WHITE IGNITION SWITCH HARNESS ** Starter Kill:    BLACK/ WHITE IGNITION SWITCH HARNESS Ignition +12 Volts:    BLACK / YELLOW IGNITION SWITCH HARNESS Dome Lights/Superv:    L GREEN/ RED (-) # PIN GRAY CONN. IN DR. KICK PANEL OEM Horn:    BLUE (-) STEERING COLUMN HARNESS Power Lock:    GREEN / WHITE # PIN BLUE CONNECTOR Power Unlock:    GREEN/ ORANGE TO LEFT OF FUSE BLOCK *** Trunk Release:    N/A Alarm Input Wire:    L GREEN/ RED (-) # PIN GRAY CONN. IN DR. KICK PANEL Notes: ** WHITE Wire Changes To WHITE/ BLACK At Base Of Steering Column. *** See Note #201 - Negative Pulse Door Lock Diagram.

if you look at your fuse box there will be some male blade  terminal plugs with no plugs in them (i think there are 3), one of those is  the parking lights just test the terminal with a DMM for 12v with the parking lights on then just put a female spade connector on the parking light wire and plug it into that spot on the fuse box and that should be it.