2004 Nissan Altima remote start problem

Like earlier stated did you bypass the clutch?  If that is not the case did you try tach learning the alarm or are you using voltage sense?

really how would i set up that relay on the acc?

I already bypasses the clutch, before the main problem was that when i tryed remote starting the car, it just cranked over. I check the 555u and it was fine. I then tryed to use the second ignition wire relay set up and it remote started with out a problem, but then when i would start the car normally , by putting the key in the on position then steping on the clutch the car started. So what i did to get it running normal was disconnect the starter wires from the alarm.

Heres my question on the second ign relay setup. 87 goes to 12vt, 30 goes to the second ign, now where does 85 and 86 go to. I know that one of them goes to the ist ign but thats where im lost, do i still have the ist ign cut? or still together.

is the 555u relay clicking during remote strat. If not just try grounding the 555u. Sometimes you need to wire in a relay with a stronger ground. If thats the case

Blue black from alarm- 85

12- 86

ground- 87

30 to blue black on 555u

is the 555u relay clicking during remote strat. If not just try grounding the 555u. Sometimes you need to wire in a relay with a stronger ground. If thats the case

Blue black from alarm- 85

12- 86

ground- 87

30 to blue black on 555u