the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

1997 Merc. Mountaineer Alarm


Post ReplyPost New Topic
< Prev Topic Next Topic >
Dragorus 
Copper - Posts: 75
Copper spacespace
Joined: January 12, 2004
Location: United States
Posted: April 01, 2004 at 3:18 PM / IP Logged  
I am having a problem with the factory disarm wire....When I lock my vehicle with the new alarm I have it to pulse neg to the fact. disarm wire....But when I lock it the domelights do not shut off.....What I am noticing is the factory alarm is also sending a neg signal down the disarm wire to arm the fact system....So should I send a neg pulse with the lock function of my aftermarket alarm?....Anyone got a DEI Wiresheet or can give me info on the factory disarm and domelights / door triggers?
jfk51502003 
Copper - Posts: 221
Copper spacespace
Joined: March 04, 2004
Location: United States
Posted: April 01, 2004 at 3:33 PM / IP Logged  
12volts yellow   +  ignition harness
Starter RED / lt. blue   +  ignition harness
Second Starter     
Ignition GREEN/ purple   +  ignition harness
Notes: Two wires each at switch, both are common, only need to power 1 each during remote start.
Second Ignition     
Third Ignition     
Accessory gray / YELLOW   +  ignition harness
Notes: Two wires each at switch, both are common, only need to power 1 each during remote start.
Second Accessory BLACK/ green   +  ignition harness
Keysense     
Power Lock pink / YELLOW   -  driver kick panel
Power Unlock pink/green   -  driver kick panel
Lock Motor pink/black    driver kick panel
Unlock Motor RED / orange    driver kick panel
Parking Lights+ PURPLE / white    driver kick panel
Notes: Also found to be WHITE/ black at the rear of the switch.
Parking Lights- WHITE/ purple    driver kick panel
Hazards     
Turn Signal(L)     
Turn Signal(R)     
Reverse Light     
Door Trigger BLACK/ lt. blue   +  driver kick panel
Notes: To avoid the dome light delay and dome light time-out use the separate door triggers. In the drivers kick panel find yellow/black for the drivers door, lt. GREEN/ YELLOW for the drivers rear door, and WHITE/ purple for the rear hatch. In the passengers kick panel find gray/red for the passenger front door, and pink/lt. blue for the passengers rear door. All five wires are negative trigger and must be diode isolated together.
Dome Supervision BLACK/ lt.blue   +  driver kick panel
Trunk/Hatch Pin common with doors    
Hood Pin tan/lt.green   -  driver kick panel
Trunk/Hatch Release     
Power Sliding Door     
Factory Alarm Arm arms on lock    
Notes: Arms on lock only with door open. It is necessary to send a signal to door trigger as well as lock to arm factory alarm.
Factory Alarm Disarm dk. GREEN/ purple   -  driver kick panel
Disarm No Unlock     
Tachometer tan / YELLOW  AC  PCM
Notes: The PCM is located at the top of the firewall towards the passenger side, the tan / YELLOW tach wire is also found at the back of the instrument cluster.
Wait to start     
Brake Wire lt.green   +  driver kick panel
Parking Brake     
Horn Trigger yellow/lt. green   -  steering column
Memory Seat 1     
Memory Seat 2     
Memory Seat 3     
1997 Merc. Mountaineer Alarm -- posted image.
Immobilizer Bypass Module:Required: YesType: PATSPart #: 555F or 555U
Notes: N/A
1997 Merc. Mountaineer Alarm -- posted image.      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
Dragorus 
Copper - Posts: 75
Copper spacespace
Joined: January 12, 2004
Location: United States
Posted: April 01, 2004 at 3:42 PM / IP Logged  
Is that for the 97 ?
jfk51502003 
Copper - Posts: 221
Copper spacespace
Joined: March 04, 2004
Location: United States
Posted: April 01, 2004 at 4:47 PM / IP Logged  
yup...hope it helps...!!!
Dragorus 
Copper - Posts: 75
Copper spacespace
Joined: January 12, 2004
Location: United States
Posted: April 01, 2004 at 5:12 PM / IP Logged  
Thanx a bunch!

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, April 18, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer