Clifford 3.5 install question

Home / the12volt's Install Bay / Car Security and Convenience / Clifford 3.5 install question (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

Medievilknight

Member - Posts: 1

Joined: May 04, 2004

Location: United States

Posted: May 09, 2004 at 7:28 PM / IP Logged

I'm going to install this alarm into my 98 grand cherokee and was thinking of adding a couple of modules (like motion sensor, window roll up) , and i was wondering if i can install these modules through a switch...so i can turn them off. Sometimes i bring my dog around with me and would hate to come back to the car and see her head in the window, or have my alarm going off all the time...

Search for other posts by Medievilknight

draasch

Gold - Posts: 2,172

Joined: February 07, 2003

Location: Florida, United States

Posted: May 09, 2004 at 9:49 PM / IP Logged

yes you should be able to add a switch on each setup....

Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

foskin007

Member - Posts: 7

Joined: May 08, 2004

Location: Ireland

Posted: May 12, 2004 at 2:57 PM / IP Logged

A Sugesstion is to break the interior sensor control wire usually the orange on the alarm module and fit a relay in between the break controled by one of the extra channel Channel 3 "Grep With Purple Stripe on wiring loom "Channel 3 " on the remote control Buttton 3 on 4 Channel remote or button 2 on its own on a 2 button remote control . You can then press channel 3 prior to arming the alarm as normal. Button 2 to click relay and then arm alarm as normal.

Jimbo

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Clifford 3.5 install question

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.