Question About Pulling Mold

Well actually I already pulled the mold and did so prior to it being completely dry. That didn't turn out too bad but the mold is L shaped and kinda leans forward some. I figure the obvious way to fix this is to put some braces in to support the floor against the slightly leaning wall but wonder if there may be any structure issues by doing this. Should I finish this or scrap it and start a new one? Naturally I'd prefer not to scrap.

i would start over.dream it, build it, fiberglass it

i would start over as well........you could always throw a couple of braces in there to strengthen it and keep it standing straight