Problems after first alarm install(AG-5)

Home / the12volt's Install Bay / Car Security and Convenience / Problems after first alarm install(AG-5) (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Page < Prev Topic Next Topic >

auex

Platinum - Posts: 5,041

This member has made a donation to the12volt.com. Click here for more info.

Joined: December 23, 2002

Location: Arizona, United States

Posted: May 14, 2004 at 7:21 PM / IP Logged

Ok, if it remote started with the key in the cylinder then there is something wrong with the wiring of the 555L or the 555L was bad out of the box, it is known to happen. First thing first, unplug the 555L for 30 seconds, then plug it back in and start the truck with the key. Then ground the BLACK/ blue and try to remote start the truck. If it works then you haven't found the correct output wire from the alarm. If it doesn't work double check the wiring, if the wiring checks out then you may have a bad module but verify with 100% confidence that the wiring is correct. Where did you tag the yellow Rcode wire at? Try tagging it in the ign harness to be sure that it is the correct wire. If the alarm is pretty new and was manufactured by dei then you need to use the third ignition output as stated before for the activation input. It is on the 12 pin harness that has the brake input and hood trigger input.

Certified Security Specialist

Always check info with a digital multimeter.

I promise to be good.

Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

Back to Top

Cisco112

Member - Posts: 8

Joined: June 03, 2003

Location: United States

Posted: May 16, 2004 at 3:25 AM / IP Logged

First I like to begin this post by saying thanks to Profuse, Laren5, & Auex for there info. and help with the minor problems I encounter with the install of the AG5 system.

I began the day by following Auex advice and rechecking the wiring on the 555L unit. Then I followed the next step to unplug it and wait the 30 sec. etc. To no surprise the truck did not remote start. I decided to troubleshoot all the wires that needed the 12v with the DMM. I came to the conclusion that the pink wire on the 555L was not getting a 12v during the remote start sequence. The reason this happened was because I had connected it to the ignition key side area of the wire (the immobilizer unit does not allow a 12v until the key is in the run position). This didn't allow the 555L to grab the R-code and was causing the truck not to start via remote start. I can now say that the AG5 is working properly .............and once again Thanks to Profuse, Laren5, and Auex for the help........

Also I like to thank Ciscored for helping with the install and taking on the challange...!!!!!!!!!!!!!

Back to Top

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Problems after first alarm install(AG-5)

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.