03 Dodge Ram Auto Start

Home / the12volt's Install Bay / Car Security and Convenience / 03 Dodge Ram Auto Start (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

desh187

Copper - Posts: 310

This member has made a donation to the12volt.com. Click here for more info.

Joined: September 13, 2002

Location: Canada

Posted: June 09, 2004 at 11:44 AM / IP Logged

Need wiring schematics for 2003 Ram 1500.I have omega stuff but still would like to compare with what i can get.Also has anyone tried programming an extra sentry key for this year (just not sure if it can be done on this one)as i can get oem blanks which i have done before on an Intrepid.

Thanks in advance.

kgerry

Platinum - Posts: 3,455

This member consistently provides reliable information

Joined: February 07, 2004

Location: Saskatchewan, Canada

Posted: June 09, 2004 at 1:35 PM / IP Logged

just use a 555C it's quick and easy

Kevin Gerry

Certified Electronics Technician

MECP First Class Installer

Owner/Installer

Classic Car Audio

since 1979

deviousjoker

Copper - Posts: 102

Joined: April 22, 2004

Location: United States

Posted: June 09, 2004 at 4:00 PM / IP Logged

12volts	pnk/blk & RED / wht	+	ignition harness
Starter	yellow	+	ignition harness
Second Starter	N/A
Ignition	blue (16 awg)	+	ignition harness
Second Ignition	red or RED / wht	+	ignition harness
Third Ignition	N/A
Accessory	green & orange	+	ignition harness
Second Accessory	blue & blk/wht	+	ignition harness
Notes: These wires may not be necessary for remote start.
Keysense	lt. blue	-	ignition harness
Power Lock	WHITE/ green	-	driver kick panel
Notes: Lock requires a negative trigger thru a 820 ohm resistor. Unlock requires a negative trigger thru a 330 ohm resistor. MUST use relays.
Power Unlock	same wire as power lock
Lock Motor	tan/pnk or tan/blk		driver kick panel
Unlock Motor	blue		driver kick panel
Parking Lights+	BLACK / YELLOW	+	relay under hood at pwr ctr
Parking Lights-	purple / YELLOW	-	headlight switch
Notes: Parking lights require a negative trigger thru a 330 or 1.4K ohm resistor. There is a rest resistance on the wire, so MUST use a relay to isolate away from the switch.
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light	PURPLE / black	+	automatic day/night mirror
Door Trigger		-
Notes: The LF door trigger is tan, and the LR door is tan/orange or PURPLE / orange. These wires are in the driver kick panel. The RF door trigger is tan/red, and the RR door is tan / YELLOW. These wires are in the passenger kick panel. Use all wires and diode isolate each. See DirectFax document 1076 for wiring information.
Dome Supervision	use door trigger
Trunk/Hatch Pin	N/A
Hood Pin
Trunk/Hatch Release	N/A
Power Sliding Door	N/A
Factory Alarm Arm	lt. GREEN/ orange	-	driver kick panel
Notes: This will also do door locks. Arm/lock is negative trigger thru a 2K ohm resistor. Disarm/unlock is negative trigger thru a 480 ohm resistor. Single pulse will do disarm without unlocking the doors. Unlock requires a double pulse. MUST use relays.
Factory Alarm Disarm	same wire as alarm arm
Disarm No Unlock	see factory alarm disarm
Tachometer	NOT GREEN/ orange	ac	ign coi, coil pack, or injector
Notes: Diesel tach wire use gray/black in the black plug at the PCM.
Wait to start	see DirectFax document 1091
Brake Wire	WHITE/ tan	+	brake pedal switch
Parking Brake	WHITE/ lt. green	-	parking brake switch
Horn Trigger	BLACK/ red	-	steering column
Memory Seat 1
Memory Seat 2
Memory Seat 3

03 Dodge Ram Auto Start -- posted image.

Immobilizer Bypass Module:	Required: Yes	Type: Sentry Key	Part #: 555C or 555U
Notes: Only vehicles with gray keys have the immobilizer.

First Class MECP Installer

deviousjoker

Copper - Posts: 102

Joined: April 22, 2004

Location: United States

Posted: June 09, 2004 at 4:03 PM / IP Logged

12volts	pnk/blk & RED / wht	+	ignition harness
Starter	yellow	+	ignition harness
Second Starter	N/A
Ignition	blue (16 awg)	+	ignition harness
Second Ignition	red or RED / wht	+	ignition harness
Third Ignition	N/A
Accessory	green & orange	+	ignition harness
Second Accessory	blue & blk/wht	+	ignition harness
Notes: These wires may not be necessary for remote start.
Keysense	lt. blue	-	ignition harness
Power Lock	WHITE/ green	-	driver kick panel
Notes: Lock requires a negative trigger thru a 820 ohm resistor. Unlock requires a negative trigger thru a 330 ohm resistor. MUST use relays.
Power Unlock	same wire as power lock
Lock Motor	tan/pnk or tan/blk		driver kick panel
Unlock Motor	blue		driver kick panel
Parking Lights+	BLACK / YELLOW	+	relay under hood at pwr ctr
Parking Lights-	purple / YELLOW	-	headlight switch
Notes: Parking lights require a negative trigger thru a 330 or 1.4K ohm resistor. There is a rest resistance on the wire, so MUST use a relay to isolate away from the switch.
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light	PURPLE / black	+	automatic day/night mirror
Door Trigger		-
Notes: The LF door trigger is tan, and the LR door is tan/orange or PURPLE / orange. These wires are in the driver kick panel. The RF door trigger is tan/red, and the RR door is tan / YELLOW. These wires are in the passenger kick panel. Use all wires and diode isolate each. See DirectFax document 1076 for wiring information.
Dome Supervision	use door trigger
Trunk/Hatch Pin	N/A
Hood Pin
Trunk/Hatch Release	N/A
Power Sliding Door	N/A
Factory Alarm Arm	lt. GREEN/ orange	-	driver kick panel
Notes: This will also do door locks. Arm/lock is negative trigger thru a 2K ohm resistor. Disarm/unlock is negative trigger thru a 480 ohm resistor. Single pulse will do disarm without unlocking the doors. Unlock requires a double pulse. MUST use relays.
Factory Alarm Disarm	same wire as alarm arm
Disarm No Unlock	see factory alarm disarm
Tachometer	NOT GREEN/ orange	ac	ign coi, coil pack, or injector
Notes: Diesel tach wire use gray/black in the black plug at the PCM.
Wait to start	see DirectFax document 1091
Brake Wire	WHITE/ tan	+	brake pedal switch
Parking Brake	WHITE/ lt. green	-	parking brake switch
Horn Trigger	BLACK/ red	-	steering column
Memory Seat 1
Memory Seat 2
Memory Seat 3

Immobilizer Bypass Module:	Required: Yes	Type: Sentry Key	Part #: 555C or 555U
Notes: Only vehicles with gray keys have the immobilizer.

First Class MECP Installer

deviousjoker

Copper - Posts: 102

Joined: April 22, 2004

Location: United States

Posted: June 09, 2004 at 4:35 PM / IP Logged

12volts	pnk/blk & RED / wht	+	ignition harness
Starter	yellow	+	ignition harness
Second Starter	N/A
Ignition	blue (16 awg)	+	ignition harness
Second Ignition	red or RED / wht	+	ignition harness
Third Ignition	N/A
Accessory	green & orange	+	ignition harness
Second Accessory	blue & blk/wht	+	ignition harness
Notes: These wires may not be necessary for remote start.
Keysense	lt. blue	-	ignition harness
Power Lock	WHITE/ green	-	driver kick panel
Notes: Lock requires a negative trigger thru a 820 ohm resistor. Unlock requires a negative trigger thru a 330 ohm resistor. MUST use relays.
Power Unlock	same wire as power lock
Lock Motor	tan/pnk or tan/blk		driver kick panel
Unlock Motor	blue		driver kick panel
Parking Lights+	BLACK / YELLOW	+	relay under hood at pwr ctr
Parking Lights-	purple / YELLOW	-	headlight switch
Notes: Parking lights require a negative trigger thru a 330 or 1.4K ohm resistor. There is a rest resistance on the wire, so MUST use a relay to isolate away from the switch.
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light	PURPLE / black	+	automatic day/night mirror
Door Trigger		-
Notes: The LF door trigger is tan, and the LR door is tan/orange or PURPLE / orange. These wires are in the driver kick panel. The RF door trigger is tan/red, and the RR door is tan / YELLOW. These wires are in the passenger kick panel. Use all wires and diode isolate each. See DirectFax document 1076 for wiring information.
Dome Supervision	use door trigger
Trunk/Hatch Pin	N/A
Hood Pin
Trunk/Hatch Release	N/A
Power Sliding Door	N/A
Factory Alarm Arm	lt. GREEN/ orange	-	driver kick panel
Notes: This will also do door locks. Arm/lock is negative trigger thru a 2K ohm resistor. Disarm/unlock is negative trigger thru a 480 ohm resistor. Single pulse will do disarm without unlocking the doors. Unlock requires a double pulse. MUST use relays.
Factory Alarm Disarm	same wire as alarm arm
Disarm No Unlock	see factory alarm disarm
Tachometer	NOT GREEN/ orange	ac	ign coi, coil pack, or injector
Notes: Diesel tach wire use gray/black in the black plug at the PCM.
Wait to start	see DirectFax document 1091
Brake Wire	WHITE/ tan	+	brake pedal switch
Parking Brake	WHITE/ lt. green	-	parking brake switch
Horn Trigger	BLACK/ red	-	steering column
Memory Seat 1
Memory Seat 2
Memory Seat 3

Immobilizer Bypass Module:	Required: Yes	Type: Sentry Key	Part #: 555C or 555U
Notes: Only vehicles with gray keys have the immobilizer.

First Class MECP Installer

jcap

Member - Posts: 41

Joined: May 14, 2004

Location: Canada

Posted: June 09, 2004 at 11:41 PM / IP Logged

on programming extra key, yes you can . as long as you have 2 programed keys. if you have a owner manual .

the instruction is there..

jcap

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

03 Dodge Ram Auto Start

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.