Window module in 95 eclipse

I'm having problems getting my window module to work. It's a stingpro pw-200 I purchased off of ebay. I'm trying to get the module to roll up the windows when arming it. The 12 volt source I am using is from the ignition (not sure if that's what i should be using or not), i've connected the driver's UP window switch and motor to the respective wires, grounded the module. The part where I think I F-ed up is the starter kill relay. I wired the solid yellow to the alarm brain and the yellow/white to the kill switch...is that right?

if you would like window to go up  you need to cont to the orange if that the one that put out the ground with arm from your alam wich my go the the startkill. 

with some window module the yellow wire is the up wire.

do a test with your window moudule ok you have a yellow wire and a yellow/white. one of those wire make the window go up in one make it go down. take one of those wire in put it to ground on the body of the car in see what happen. the window wil go up or down.

you may have a black wire/white  if your use your module to roll win up or down. this lop need to be cut. this with most  window moudule.

check out paper work that come with your module,