Compustar remote start wont work

ok it should be wired like this:

Alarm (CN1)---------------Your car(1996 Sunfire)

Red--------------------------Red (ign switch)

Gr/Wh---------------------- Brown  (drivers kickpanel main harness)

RED / Wh--------------------Red (ign switch)

Wh--------------------------Orange (ign switch)

Voilet-----------------------XXXXXXX (pre-wired)

Yellow--------------------- Yellow (motor side of starter)

Yellow/black------------- Yellow (key side of starter)

Gr/Rd-----------------------Pink

Black-----------------------Ground

On the RED / wh wire from the alarm you will have another relay. You MUST connect the Blue relay wire to the white wire in your Ign switch. The car will not remote start without that connected. Thats the 2nd ignition. The left over purple wire goes to the (-) accessory output from the alarm CN2. Your car wont start without these wires connected. If you still have problems the compustar should give you a fault code to tell you whats not connected right. Also check the Tach wire, or learn the Tach again.

Good Luck,

Krazzyborri

Ok man here is the wiring for that relay.

Relay Terminal--------------Wire color

#30------------------------------Blue

#85------------------------------Purple

#86 & #87---------------------Jump Them together

#87-----------------------------Constant 12V

#87a-(mid terminal)-------No Use

Now just use the previous info that I posted for the blue and purple wires.

Good Luck