new ’94 civic trunk for CIAA show

We are now enterered in the 'best of install' @ the upcomming CIAA show on July 1st.   We have a full show car to enter forthe rest of the comp, but there is one problem, it has nothing in the trunk.   The rest of the civic is covered with red & silver crushed metallic velvet, this is what we have to work with:

We decided to look at some Alpine type-r equipment, two dual 4ohm 10"s, and two 420's to run them to be exact. We also picked up a pre-fab (we only have a week to finish the rest of the car) that would hold the subs where we want them:

We layed out the amps where we wanted them, kinda tight fit... it's gonna be fun:

I cut a trim to fit in the rear deck/tailgate area:

At this point i cut two plates to hold the precious Apline 420's:

We then decided to mock the audio equip. and take a look at what it would look like.... well we did this every 10 mins..... were kinda inpatient:

Looks pretty sick.... now to stretch the grill fabric, i took it out and used speaker grille cloth and staples:

Then we masked the trunk and put in the stretched trim:

Looking pretty good....... then we got it gooey:

Unforutanately after this point, things didn't come out quite the way we planned:

So we cleaned the trim, cut new plugs, and restretched, this time with Fish Fabric......good stuff....  oh, and this time, well use PVA & Tape on the plugs......:

Anyway.... that's all for now.... will update before the show.... hope you boys like..... and i hope the competition isn't reading.... they might know what to expect...... under all that pretty fascia, is a boring old pre-fab.....

Got an update!!!  

We resined it again... this time it was strong enough to remove:

That's the way to do it!.....

Hope you like everybody.............   We are now gonna resin the back of it.... will take more pics.

30 mins later....

nextstep, finish glassin.... and test fit with equipment

10 minutes after that.....

Pretty quick posts..... you want thorough, i'll give you thorough....... real time baby.