the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

Schematics Request: 1993 BMW 325is


Post ReplyPost New Topic
< Prev Topic Next Topic >
sigma_x 
Member - Posts: 28
Member spacespace
Joined: October 14, 2003
Location: United States
Posted: July 05, 2004 at 9:40 PM / IP Logged  
Hi, could someone please post the DEI wireing schematic for a 93 325is BMW? Thanks!
1993 BMW 325is
sigma_x 
Member - Posts: 28
Member spacespace
Joined: October 14, 2003
Location: United States
Posted: July 05, 2004 at 9:58 PM / IP Logged  
Which schematic is the right one?
https://www.the12volt.com/installbay/detail.asp?info=alarm&year=1993&make=BMW&model=325&ID=13206&type=Alarm
https://www.the12volt.com/installbay/detail.asp?info=alarm&year=1993&make=BMW&model=325&ID=13301&type=Alarm
Thanks!
1993 BMW 325is
sigma_x 
Member - Posts: 28
Member spacespace
Joined: October 14, 2003
Location: United States
Posted: July 06, 2004 at 12:36 PM / IP Logged  
Come on, somone?
1993 BMW 325is
datrick 
Member - Posts: 33
Member spacespace
Joined: June 20, 2004
Location: United States
Posted: July 06, 2004 at 12:55 PM / IP Logged  
BMW / 3 SERIES / 1993 / Remote Start
[PRINT THIS PAGE]
12volts RED / wht or red   +  ignition harness
Starter blk/yel or black   +  ignition harness
Second Starter     
Ignition green   +  ignition harness
Second Ignition pur/wht or purple   +  ignition harness
Third Ignition     
Accessory     
Second Accessory     
Keysense     
Power Lock WHITE/ red   +  factory alarm plug
Notes: The alarm plug is a black 12 pin plug located just behind the glove box. It is mounted with the pins facing you atop a vent just to the left of the body computer. Other wires at the alarm plug are: 12V- RED / white; Accessory- PURPLE / white; Siren- BLACK/ blue; Ground- BROWN / orange. Do not use the power sources at the alarm plug to operate high-current devices. The other side of the siren wire is mounted in a 2 pin plug at the passenger rear corner of the engine compartment. The other wire in the plug is a brown ground wire. DEI recommends attaching the siren at this point.
Power Unlock blue/red   +  factory alarm plug
Notes: The alarm plug is a black 12 pin plug located just behind the glove box. It is mounted with the pins facing you atop a vent just to the left of the body computer. Other wires at the alarm plug are: 12V- RED / white; Accessory- PURPLE / white; Siren- BLACK/ blue; Ground- BROWN / orange. Do not use the power sources at the alarm plug to operate high-current devices. The other side of the siren wire is mounted in a 2 pin plug at the passenger rear corner of the engine compartment. The other wire in the plug is a brown ground wire. DEI recommends attaching the siren at this point.
Lock Motor     
Unlock Motor     
Parking Lights+ gry/pur, gry/yel    headlight switch
Notes: These wires are the separate left and right parking light wires. Use both wires and isolate each.
Parking Lights- blue/green (hazards)    factory alarm plug
Notes: The alarm plug is a black 12 pin plug located just behind the glove box. It is mounted with the pins facing you atop a vent just to the left of the body computer. Other wires at the alarm plug are: 12V- RED / white; Accessory- PURPLE / white; Siren- BLACK/ blue; Ground- BROWN / orange. Do not use the power sources at the alarm plug to operate high-current devices. The other side of the siren wire is mounted in a 2 pin plug at the passenger rear corner of the engine compartment. The other wire in the plug is a brown ground wire. DEI recommends attaching the siren at this point.
Hazards     
Turn Signal(L)     
Turn Signal(R)     
Reverse Light     
Door Trigger    -  factory alarm plug
Notes: Door triggers are BROWN / gray for the drivers front door, BROWN / blue for the passenger front door, and BROWN / black for the rear doors (if equipped). Use all three wires and diode isolate each.
The alarm plug is a black 12 pin plug located just behind the glove box. It is mounted with the pins facing you atop a vent just to the left of the body computer. Other wires at the alarm plug are: 12V- RED / white; Accessory- PURPLE / white; Siren- BLACK/ blue; Ground- BROWN / orange. Do not use the power sources at the alarm plug to operate high-current devices. The other side of the siren wire is mounted in a 2 pin plug at the passenger rear corner of the engine compartment. The other wire in the plug is a brown ground wire. DEI recommends attaching the siren at this point.
Dome Supervision comes on with unlock    
Trunk/Hatch Pin BROWN / white   -  factory alarm plug
Notes: The alarm plug is a black 12 pin plug located just behind the glove box. It is mounted with the pins facing you atop a vent just to the left of the body computer. Other wires at the alarm plug are: 12V- RED / white; Accessory- PURPLE / white; Siren- BLACK/ blue; Ground- BROWN / orange. Do not use the power sources at the alarm plug to operate high-current devices. The other side of the siren wire is mounted in a 2 pin plug at the passenger rear corner of the engine compartment. The other wire in the plug is a brown ground wire. DEI recommends attaching the siren at this point.
Hood Pin PURPLE / green   -  
Notes: The hood pin wire can be found at the radio harness or at the hood pin switch.
Trunk/Hatch Release     
Power Sliding Door     
Factory Alarm Arm     
Factory Alarm Disarm     
Notes: If equipped with a factory alarm, the alarm will be plugged into the factory alarm plug. The only way to arm and disarm the factory alarm is with the factory remote. If your planning on using the 8360 pre-wired alarm harness the factory alarm must absent or removed.
Disarm No Unlock     
Tachometer black  AC  instrument cluster
Notes: The wire is located in a white connector behind the instrument cluster. Do not unplug the white connector with the ignition on or turn the ignition on with the plug disconnected.
Wait to start     
Brake Wire blu/red or grn/red   +  at brake pedal switch
Parking Brake     
Horn Trigger brn/red or brn/yel   -  steering column
Memory Seat 1     
Memory Seat 2     
Memory Seat 3     
Schematics Request: 1993 BMW 325is -- posted image.
Immobilizer Bypass Module:Required: NoType: N/APart #: N/A
Notes: N/A
sigma_x 
Member - Posts: 28
Member spacespace
Joined: October 14, 2003
Location: United States
Posted: July 06, 2004 at 1:28 PM / IP Logged  
Thanks :)
1993 BMW 325is

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Saturday, April 27, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer