Fosgate amp/subs

Home / the12volt's Install Bay / Car Audio / Fosgate amp/subs (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

bcuz

Member - Posts: 13

Joined: February 20, 2003

Location: United States

Posted: July 21, 2004 at 10:11 PM / IP Logged

I am going to drive two Rockford Fosgate P112S4 subs with a Rockford Fosgate P3001 amp. I am looking for suggestions on wiring the subs. I assume wiring the subs in series and running them at 2 ohms would be the best, am I correct?

Is there a way to wire them in series/parallel? Would this produce a four ohm load? If it is possible, which of the two scenarios would you recommend?

As always, thanks for any and all input. You guys are my hero.

bcuz

customsuburb

Gold - Posts: 1,813

Joined: January 17, 2004

Location: United States

Posted: July 21, 2004 at 10:14 PM / IP Logged

You will want to wire them in parallel, (to get a 2 ohm load) and get the most power out of your amp (300 watts RMS which is the suggested RMS power for the P1s).

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Fosgate amp/subs

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.