the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

96 accord alarm/remote start


Post ReplyPost New Topic
< Prev Topic Next Topic >
tek1000 
Member - Posts: 13
Member spacespace
Joined: July 26, 2003
Posted: August 07, 2004 at 7:06 AM / IP Logged  
 hi looking a diagram for 1996 honda accord for alarm and remote starter.
lilboi 
Copper - Posts: 126
Copper spacespace
Joined: May 01, 2004
Location: United States
draasch 
Gold - Posts: 2,172
Gold spacespace
Joined: February 07, 2003
Location: Florida, United States
Posted: August 07, 2004 at 7:43 AM / IP Logged  
Make:   Honda
Model: Accord
Year:    1996
Alarm
Constant 12 volts WHITE IGNITION SWITCH HARNESS
Ignition 12 volts BLACK / YELLOW IGNITION SWITCH HARNESS
Starter BLACK/ WHITE IGNITION SWITCH HARNESS
Dome Light BLACK/ WHITE (-) 20 PIN GRAY CONN. BEHIND DR. DASH *
Trunk Pin Switch ORANGE (-) 20 PIN GRAY CONN. BEHIND DR. DASH *
Parking Lamp RED / BLACK (+) 18 PIN BLUE CONN. ABOVE FUSE BLOCK
Power Lock BLACK/ WHITE DRIVER KICK ** #201
Power Unlock ORANGE PANEL
* Door Trigger In Pin #5, Trunk Trigger In Pin #7 ** Door Lock Wires Found In Gray 3 Pin Connector (Gray 4 pin Conn. On Wagon) Above Fuse Block In Driver Kick Panel Taped To Harness With Blue Tape. #201- See Negative Pulse Door Lock Diagram
Accessories
Window Up D\ RED / YEL P\ BLU/YEL D\ GRN/BLU P\ YELLOW @ MAIN #211
Window Down F/ RED / BLU F/ BLUE R/ GREEN R/ YEL/GRN SWITCH
Ign Key Warn BLUE/WHITE (-) IGNITION SWITCH HARNESS
Trunk Release N/A CABLE OPERATED
OEM Horn BLUE/RED (-) STEERING COLUMN HARNESS
Headlights BLUE (-) (COUPE) OR BLUE/RED (-) (WAGON)BEHIND DR. DASH *
OEM Alarm Arm YEL/RED OR WHT/RED (-) 3 PIN GRAY CONNECTOR TAPED TO
OEM Alarm Disarm YEL/RED OR WHT/RED (-) HARNESS IN DRIVER KICK PANEL **
#211- See Reversal Rest At Ground Power Window Circuit Diagram. * Headlight Wire Located In Blue 20 Pin Connector Behind Driver Dash To Left Of Steering Column. ** Schematics Do Not Specify Which Wire One Of The Two Wires Listed Is Arm Or Disarm. 3 Pin Gray Connector On Coupe Or Sedan Only. 4 Pin Gray Connector In Same Location On Wagon.
Remote Start
Tach Signal BLUE TACH TEST CONN. ON PASS. STRUT TOWER*
Ignition #2 YELLOW IGNITION SWITCH HARNESS
Ignition #3 N/A
Accessory WHITE/ BLACK IGNITION SWITCH HARNESS
Neutral Safety NOT GROUNDING TYPE - OEM SWITCH OPENS STARTER CIRCUIT
Brake Light GREEN / WHITE (+) AT SWITCH ABOVE BRAKE PEDAL
Reverse Light GREEN/ BLACK (+) 16 PIN CONNECTOR IN DRIVER KICK PANEL
Rear Window Defrost YELLOW/WHITE (-) AT REAR WINDOW DEFOGGER SWITCH
* BLUE Tach Wire Also Located In 18 Pin Blue Connector On Top Of Fuse Block In Driver Kick Panel.
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
tek1000 
Member - Posts: 13
Member spacespace
Joined: July 26, 2003
Posted: August 20, 2004 at 10:27 PM / IP Logged  
 I have a 1996 accord I put in my alarm with remote start its a scytek 5000rs-2w it went well every thing worked fine.2weeks later I took the car to a shop to have my coil overs installed so I put the alarm in valet mode.So when I pick up the car the alarm was out of valet mode and when I drive the car the door locks keep locking and unlocking but do not work from the switch or remote I check the fuse and the alarm wires to the door locks they look fine can not understand what went wrong and the shop said they did not mess with the alarm or the door locks anybody have any idea of whats happing or how to fix this problem.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, April 26, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer