need help install alram 2001 civic

Home / the12volt's Install Bay / Car Security and Convenience / need help install alram 2001 civic (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

hondatech

Member - Posts: 5

Joined: September 06, 2002

Location: Canada

Posted: September 19, 2002 at 11:05 AM / IP Logged

hey guys i need help on an install on a 2001 civic. I cant get the alarm to lock unlock the door locks on this vehicle, its a predator 2001 alarm and it has 2 wires that send 300ma positive and negtive signal and it just doesnt seem to work, the power doorlocks are positive trigger on this vehicle. i used the yellow/blk for lock behind the fuse box and yellow/grn for lock and they both send positive signal. and the car only has a keyless entry module in it which i left in thanks.

ag

Back to Top

naughtydog

Copper - Posts: 90

Joined: May 02, 2002

Location: United Kingdom

Posted: September 19, 2002 at 3:12 PM / IP Logged

If you pulse the unlock wire on the vehicle with a full positive - do the doors unlock??

If they do, then you're 300ma output is not enougfh to drive the original unlock wire. You would need to add a relay as follows:-

30 = Connect to poitive 12V

85 = connect to unlock wire from alarm

86 = connect to poitive 12V

87 = connect to unlock wire on vehicle.

If they dont, you have the wrong wire on the vehicle...

Hope this helps

Naughtydog

Back to Top

kickyride

Copper - Posts: 100

Joined: September 20, 2002

Location: Georgia, United States

Posted: September 20, 2002 at 11:19 AM / IP Logged

Actually, the power doorlocks on this car should be negative pulse. You have likely found your door lock motor wires. You need to tap into WHITE/ Blue for lock and WHITE/ green for unlock. They will beoth be in a 20 pin connector located in the driver's kick panel. The locks should activate whenever you tap these wires to ground. Hope this helps.

Mike

Sales/Tech Support - KICKYRIDEoCOM mobile electronics

MECP 1st class-Security Specialist

Back to Top

sador

Copper - Posts: 57

Joined: March 25, 2002

Location: United States

Posted: September 21, 2002 at 10:52 AM / IP Logged

Hi

The problem is that you have the wrong wire you need to used this Power Lock:WHITE/ Blue (-)

Power Unlock:WHITE/ green(-)

That's what I have on my civic and work fine

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

need help install alram 2001 civic

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.