2000 Olds Alero

I have installed Bulldog keyless entry on my Alero, using the wiring information from the Bulldog site. I can't locate the park light circuit on the BCM. the diagram says brown + on the grey 16 pin connector. There is only one brown wire on that connector and it shows nothing other than constant ground, no pulse or voltage when the doors lock. Any ideas or just go for the park light wiring off the switch?

Thanks

Try looking over in the passenger kick panel as well for the BROWN wire

The brown wire is at the head light switch in '99-00 aleros and is behind the radio on '01-02 cars. Hope this helps.

Mike

Thanks for the help, but this car has the built in lock delay. Waits about 5-7 seconds from last door close, then locks the door and flashes the parking lights twice. This has to be coming from the BCM, so why would I need to go right to the light switch??

Alero

\

Continued message 3

Probed every wire on the BCM and no luck, finally took kickyride's advice and just used the headlight switch wireing, much easier and works fine.

Thanks for the help