the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

Amp Cooling


Post ReplyPost New Topic
< Prev Topic Next Topic >
ashcan 
Member - Posts: 10
Member spacespace
Joined: October 19, 2004
Location: United States
Posted: October 19, 2004 at 4:27 PM / IP Logged  

I have just had a Memphis 1000d installed in my car runnin 2 Kicker Solo 12s...

They wired it down to 1 Ohm...and it sounds great but the problem is heat....I have it hid in a small compartment in my car and I need to cool it off...

A friend sugested using 80mm Computer fans and I was wondering if this is the most logical Idea....

And if it is a good idea do I need to do anything special to hook them up and how would you sugest doing so...

Ravendarat 
Platinum - Posts: 2,806
Platinum spacespace
Joined: February 23, 2004
Location: Canada
Posted: October 19, 2004 at 4:33 PM / IP Logged  

Specifically what kinda car and where is the amp exactly

double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer
jeffchilcott 
Platinum - Posts: 2,483
Platinum spacespace
Joined: April 11, 2002
Location: United States
Posted: October 19, 2004 at 4:38 PM / IP Logged  
if you are not experienced with this type of thing have it hooked to the board my a tech.   you can use your remote power source to kick this fan on but not always the best route.
2009 0-1000 Trunk WR 154.0DB 2009 1001+ Trunk WR
2007 USACI World Champion
2007 World Record
2006 USACI Finals 2nd Place
ashcan 
Member - Posts: 10
Member spacespace
Joined: October 19, 2004
Location: United States
Posted: October 19, 2004 at 4:46 PM / IP Logged  

I have plenty of experiance...I work with cars so I know how a 12Volt sys works...

its a 1999 isuzu rodeo and the amp is behind the rear plastic panel on the drivers side...You can see it through the opening where the Jack used to be...I want to use some of the illuminated fans but I was worried If I pulled power off the remote that it would drop too low to turn the amp on...So do I need to run a new wire back to the amp for the fans

and will the regular Computer fans work as is..or do I need to put a resistor on them or something....

saranykm 
Member - Posts: 23
Member spacespace
Joined: September 30, 2004
Location: United States
Posted: October 19, 2004 at 5:44 PM / IP Logged  
u should be able to because i have three computer cooling fans cooling the brain on my video system, and my two amps....just remember, you might need a ground loop isolator if you do that...you might get a "whining" sound if you do that. i use those  same fans...infact i have the ones that light up, its pretty cool
gorilla
Ravendarat 
Platinum - Posts: 2,806
Platinum spacespace
Joined: February 23, 2004
Location: Canada
Posted: October 19, 2004 at 6:26 PM / IP Logged  
If I was you I would by a larger turbine fan like what stinger makes. They sell for about 30 bucks. They look kinda like a paper towel tube but move alot more air. They draw very little power so you could just use a relay and tap into the main power wire used for the amp to power the relay and then just use the remote to switch the relay on. Also if you use a relay you should not experience any type of feedback like what saranykm described because the relay will isolate the fan.
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Sunday, May 5, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer