2004 ford crown vic police package

i need a wiring diagrahm foe the 2004 ford crown vic door locks. i am trying to in stall a key less entry

DIRECTWIRE™ WIRING INFORMATION - FORD / CROWN VICTORIA / 2004 / Keyless Entry [PRINT THIS PAGE] 12volts brown and lt. green   +   ignition harness Starter RED / lt. blue   +   ignition harness Ignition WHITE/ yellow   +   ignition harness Power Lock pink / YELLOW      driver kick, door harness Notes: Without keyless entry the door locks are 5wi (reverse polarity). With keyless entry they are positive trigger. Power Unlock pink/lt. green      driver kick, door harness Notes: Without keyless entry the door locks are 5wi (reverse polarity). With keyless entry they are positive trigger. Lock Motor pink/black   5wi driver kick, door harness Unlock Motor RED / orange   5wi driver door motor in door Parking Lights+ brown   +   pin 4, blk plug @ LCM Notes: The LCM (Lighting Control Module) is to the right of the steering column. Parking Lights- WHITE/ black   -   pin 13, gry 16P plug @ LCM Notes: The LCM (Lighting Control Module) is to the right of the steering column. Hazards same as turn signals        Turn Signal(L) lt. GREEN/ orange   +   steering column Turn Signal(R) ORANGE / lt. blue   +   steering column Door Trigger dk. blue and BLACK/ orange   -   LCM Notes: Blue is the driver door trigger wire, it is in pin 11, gray 22 pin plug. BLACK/ orange is the three passenger doors, it is in pin 11, gray 16 pin plug. Use both wires and diode isolate each. The LCM (Lighting Control Module) is to the right of the steering column. Dome Supervision use door trigger        Trunk/Hatch Release purple / YELLOW   5wi driver kick, harness to rear Notes: The fuel door release is WHITE/ pink (+) in the driver kick, harness to rear. Power Sliding Door N/A        Factory Alarm Arm N/A        Factory Alarm Disarm N/A        Disarm No Unlock N/A        Horn Trigger dk. blue   -   steering column Memory Seat 1 N/A        Memory Seat 2 N/A        Memory Seat 3 N/A        Immobilizer Bypass Module: Required: Yes Type: SecuriLock Part #: 556U or 555U Notes: N/A        This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.