Advise for Alarm/starter install

Home / the12volt's Install Bay / Car Security and Convenience / Advise for Alarm/starter install (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

jonezybonezy

Member - Posts: 1

Joined: December 05, 2004

Location: United States

Posted: December 05, 2004 at 5:47 PM / IP Logged

I'm about to attemp an install of a Crimestopper 20011IV Alarm/Starter on a 2002 Altima. Does anyone know where I can get a wiring diagram for this vehicle? Any special tools, or connectors that I might need. I did pick up a Universal transponder bypass.I'm pretty proficient in stereo's. This is my first alarm though.

Any help/advise would be greatly appreciated.

Thanx

Jonezybonezy

cqljohn

Member - Posts: 3

Joined: November 25, 2004

Posted: December 05, 2004 at 7:46 PM / IP Logged

Try here............

http://bulldogsecurity.com/New%20Wires/New%20Wires/Wires/nisaltima02-05.htm

wiring was correct for my vehicle, but you may want to double check.

daniel2002p

Silver - Posts: 524

Joined: October 10, 2003

Location: United States

Posted: December 05, 2004 at 8:20 PM / IP Logged

Nissan

Altima

2002

Remote Starter Wiring Colors and Notes
Function	Vehicle Color	Location
Start:	BLACK/ RED & BLACK / YELLOW	IGNITION SWITCH HARNESS **
Ignition #1:	BLACK/ RED	IGNITION SWITCH HARNESS*
Ignition #2:	RED	IGNITION SWITCH HARNESS
Ignition #3:	N/A
Accessory:	WHITE/ BLUE	IGNITION SWITCH HARNESS
Brake Light:	RED / GREEN	AT SWITCH ABOVE BRAKE PEDAL
Tach Signal:
Parking Lights:	RED / BLUE (+)	DRIVER'S KICK PANEL
Headlights:	BLUE & RED / YELLOW (+)	AT MODULE BEHIND PASSENGER HEADLIGHT
Diesel Glow Plug:	N/A
Clutch Bypass Wire:
Notes:	* This Vehicle Is Equipped With A Transponder Type Engine Immobilizer Theft System. Use Universal Alarm Bypass Module part # 2x402 where X can be any number. See Note #144 This Vehicle Is Equipped With Two Start Wires. Both Must Be Powered In Order For Vehicle To Start When Engine Is Cold. See Note #235 * Test With A Meter While Turning A Key In The Driver's Door Lock Cylinder.

Nissan

Altima

2002

Alarm and Keyless Entry Wiring Colors and Notes
Function	Vehicle Color	Location
Constant +12 Volts:	GREEN	IGNITION SWITCH HARNESS
OEM Alarm Disarm:	WHITE/ BLUE (-)	AT KEY SWITCH INSIDE OF DRIVER'S DOOR ***
Dome Lights/Superv:	COMES ON WITH UNLOCK	SEE NOTE****
OEM Horn:	GREEN / WHITE (-)	STEERING COLUMN HARNESS
Power Lock:	PINK (-)	PIN # AT BCM NEAR FUSE BOX
Power Unlock:	BROWN (-)	PIN # AT BCM NEAR FUSE BOX *****
Trunk Release:	RED / BLACK OR BLUE/RED (-)	PIN # AT BCM NEAR FUSE BOX
Alarm Input Wire:	COMES ON WITH UNLOCK	SEE NOTE****
Notes:	** Multiple Trigger Wires. Use Lt. Blue (-) For Driver's Door, Pink/Blue (-) For Passenger Front Door, RED / Black (-) For Both Rear Doors. All Wires Are Found At The BCM Located To The Right Of The Fuse Box. *** Unlock Requires Double Pulse. See Note #231. Also See Note #201 Negative Trigger Door Locks.

2005 Toyota Corolla S

1.8L VVT-i I-4

Always double check your wires with a DMM!!!

Do Not Use A Test Light!!!

MECP Certified Installer!

Best Buy 665 - IN IT TO WIN IT! TEAM MOBLE!

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Advise for Alarm/starter install

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.