Need to power 3nd ignition

Home / the12volt's Install Bay / Car Security and Convenience / Need to power 3nd ignition (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

link123

Member - Posts: 21

Joined: August 29, 2004

Location: United States

Posted: December 09, 2004 at 1:22 PM / IP Logged

I have a remote starter that only have 2 ignition (+) output, but the vehicle has three ignition wire. I want to power the 3rd ignition up. What is the proper relay layout to do this?

thanks

Shawn

hagmanti

Silver - Posts: 304

Joined: September 14, 2004

Location: United States

Posted: December 09, 2004 at 1:54 PM / IP Logged

Pin 85 to ign2. Pin 86 to ground when running of the remote start. Pin 30 to 12V. Pin 87 to ign3.

Your remote start might have an ignition output (a low current, thin guage wire that outputs a negative pulse when ignition should be active). For aesthetic reasons, if it has such a wire, hook that wire to pin 86.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Need to power 3nd ignition

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.