Setup Q’s?

Kenwood Kac-626 specs... http://memimage.cardomain.net/member_img_a/702322_14_full.jpg Sub specs..... 2 12" Kicker EX1204 125RMS each into 4 Ohms (SVC) Someone show me what is the best setup i can wire this system??? Cheers :)

by my gathering your amp is 2ohm stable, so with those 4ohm svc's this looks to be about right

Whoooa... wait up there a sec. I think you may be wrong on this one /r7... You'd be right on if that amp really was 2-ohm stable MONO, but that's a 2-channel amp, right? Almost ALL 2-channel amps are not 2-ohm stable when bridged. Many $1000 2-channel amps are not 2-ohm stable bridged! You amp would be short lived, I'm afraid, if you wired it like that. Either wire it in series, giving the amp an 8-ohm load bridged, and dropping your wattage by about about 1/2, or run each channel to a sub (stereo mode). I hope you see this mrdragon!New Project: 2003 Pathfinder

Thanks kfr01 i got ur private msg. I got another amp, but diff brand and model...do you recommend me BRIDGED each amp to run each sub??? I did try last time but its very hard to get both diff amp to match each other. Or it can be done??? Thanks :)

So... tell me about this other amp. You now have 2 amps?New Project: 2003 Pathfinder

Ok here is the info on my another amp.... http://memimage.cardomain.net/member_img_a/702322_15_full.jpg

Why don't you sell those two amps and get one 2-ohm stable mono class-d amp? It would be far more appropriate for you. I don't like the idea of trying to shoe-horn something together, do you?New Project: 2003 Pathfinder

my bad, thanks for saving his amp ;p btw i looked at the spec sheet again and if i was paying attention, and as you said, its not 2Ohm stable.

What I want to know is, mrdragon down under:   do you do installs for a lot of other people or do you keep switching up stuff for your own system??

Just for my own use....i am on tight budget atm. See atm i am running 2 12" and my amp can only produce 50RMS per sub...and i was think if i can double the power by putting in a second amp...then why not...since the second amp can only max 100RMS.