Replacing Factory Sub

Home / the12volt's Install Bay / Car Audio / Replacing Factory Sub (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

Jvee

Member - Posts: 26

Joined: September 16, 2004

Location: United States

Posted: December 26, 2004 at 1:24 PM / IP Logged

The premium sub on a 2004 Subaru Forester XT is mounted in rear and is a 6x9. Not the best. I wanted to remove and substitute a factory plastic pocket that fits inside. Dimensions of the pocket are at least 4.5" deep, 5.5" wide, and 10" long. Is there a 6" or 8" driver that I can use in that space to take the place of the weak sub. I will feed it 120 watts bridged @ 4 ohms mono. I was thinking that I would seal pocket with MDF on top and fill with poly. Maybe place fiberglass or sound deadening on outside of pocket. Any ideas?

Back to Top

Bestbuy577

Member - Posts: 31

Joined: December 29, 2004

Location: United States

Posted: December 30, 2004 at 9:53 AM / IP Logged

Rockford Fosgate actually makes an 8inch sub driver that is reletively cheap...just check out their site http://www.rockfordfosgate.com

Best Buy Store#577 Oxford Valley, PA

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Replacing Factory Sub

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.