Starter Kill Confusion

Home / the12volt's Install Bay / Car Security and Convenience / Starter Kill Confusion (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

realsynthetics

Member - Posts: 35

Joined: November 19, 2004

Location: United States

Posted: December 27, 2004 at 11:27 PM / IP Logged

I'm a little confused as to where these wires should be routed...

http://dodgeintrepid.net/photopost/data/500/2890starter_kill_layout.jpg Starter Kill Confusion -- posted image.

I'll cover what I'm not confused with first:

-The orange wire will tap into the "ground when armed wire" and pin 86

-The violet wire from the starte rinput will be on the vehicle side of the relay setup then through on to pin 87a of the relay

-The wire on pin 30 connects to the relay side of the cut starter wire...(module side)

MY ONLY CONFUSION

There is a wire on pin 85 that is assigned to the ignition switch. Now, does this mean I need to tap this wire into ignition 1 or into ignition 2....or into something else. Any help would be appreciated. Thank you.

Back to Top

realsynthetics

Member - Posts: 35

Joined: November 19, 2004

Location: United States

Posted: December 28, 2004 at 12:26 AM / IP Logged

No ideas?

Back to Top

gcorrea

Silver - Posts: 436

Joined: May 22, 2004

Location: United States

Posted: December 28, 2004 at 12:41 AM / IP Logged

pin 85 should "see" 12volts when the key is at on and run position only.

gcorrea

Back to Top

profuse007

Gold - Posts: 2,015

Joined: October 20, 2002

Location: Texas, United States

Posted: December 28, 2004 at 12:58 AM / IP Logged

it doesnt matter which ignition wire, both will give 12volts when turning key in cyl. thus makin the starter kill relay active.

realsynthetics wrote:

No ideas?

Houston,TX

"The two most common elements in the universe are H+ and stupidity" (Ellison).

Back to Top

realsynthetics

Member - Posts: 35

Joined: November 19, 2004

Location: United States

Posted: December 28, 2004 at 5:32 AM / IP Logged

Damn you guys are good! Thanks for your prompt and accurate help.

-Duncan

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Starter Kill Confusion

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.