Installation problem

Home / the12volt's Install Bay / Car Security and Convenience / Installation problem (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

skunka

Member - Posts: 3

Joined: January 13, 2005

Posted: January 13, 2005 at 10:16 PM / IP Logged

Hi i just bought an Carbine 4600 plus car alarm . I started to install it yersterday and today when i have finished all my connexions the alarm would'nt work properly . So i read my installation manual all over again and i found a little warning that i haven't seen the first time . Here it is :

Warning do not plug the 10 pin or 5 pin wire harness into alarm control module before you begin installing the alarm.The wire harness must be plugged intoalarm control module after all connexions are made.Faillure to follow this procedure could cause some confusion with transmitter operation or alarm function operation .

So the wire harness was plugged in before the begin of the installation . It's probably the cause of my problem ? So what I do to correct it ? Can i reset the transmitter or the transmitter is bad because of the non respect of the warning ?

And i know that my english is very bad !

CutDog504

Silver - Posts: 643

Joined: May 14, 2002

Location: Louisiana, United States

Posted: January 13, 2005 at 10:55 PM / IP Logged

Sounds like you should give carbine tech support a call for that one.

metaverse

Copper - Posts: 210

Joined: June 13, 2002

Location: United States

Posted: January 13, 2005 at 11:42 PM / IP Logged

Define would not work properly first. What is it doing and what is it not doing ? unplug the alarm brain and let it sit for a while..then do a master reset and reprogram all remotes that you have. post back with results.

skunka

Member - Posts: 3

Joined: January 13, 2005

Posted: January 14, 2005 at 9:00 PM / IP Logged

All i can do with the alarm is to put in in valet mode ! I can't do nothing else .I can't arm the alarm, the remote won't work,I can't start the alarm siren . I can do nothing but enter the valet mode .If i try to arm it it doesn't work .I think that i would call a technician from carbine ...

skunka

Member - Posts: 3

Joined: January 13, 2005

Posted: January 14, 2005 at 9:00 PM / IP Logged

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Installation problem

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.