Multiple Window Modules.

Getting ready to install an Autopage 855lcd into a custom Caprice. Ordered 2 DEI530t's to allow the owner to roll all 4 windows up and down. I have 2 AU-93's laying around, and would like to use them on his ragtop motorized sunroof. I'll use one to open, and the other to close upon arming. The manual for the AU-93 recommends the installer to use the alarm's 500ma ground when armed, and not to connect it to anything else. The pink wire is to be used for another device that requires a 500ma ground when armed from the AU-93. My question is, can I use the pink wire and diode isolate each sensor, the starter kill relay, the 2 530t's, and the 508 invisibeam sensor from this pink wire, or should I just use the Autopage's ground when armed output for all the sensors?

you should use the autopage's ground out when armed and lead it to a relay that wire come out with true ground upon armed so that it's not just 500mA. then, diode isolate to each of the items that you need connect an armed out signal. good luck! all problems can be resolved with a hammer