Remote Start , bypass the run time feature?

Thank you!!!mexicang

First thing, you need to program the blue/white output as a defroster output(activates 10 seconds after the rs engages). Then you will need 2 relays and some diodes. Wire the relays according to the diagram below. The - input to latch the relays will be the WHITE/ blue. The + shut down will be the brakes + wire. Your output will need to be diode isolated(alot of them) and they will go to the ribbon harness for the acc, ign, and any other additional relays you will need to use for additional acc and ign. I would recommend you also put a toggle switch inline with the WHITE/ blue so the user can disable the unlimited run time addition. Post a reply or PM/AIM me if you have any questions. Certified Security Specialist

Always check info with a digital multimeter.

I promise to be good.

Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

Oh, and my first response still applies to normal customers. This is an exception, as I too have done RS installs for K9 vehicles.Certified Security Specialist

Always check info with a digital multimeter.

I promise to be good.

Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

Thank you i will give it a try. Again thank you very much.mexicang

Another question where does the blue with white wire go?mexicang

The WHITE/ blue comes from the 561T and goes to the latch activation wire, left side of diagram. You need 1 diode for the acc ( from the ribbon harness), 1 for ign ( frome the ribbon harness), and 1 per additional relay for the acc/ign.Certified Security Specialist

Always check info with a digital multimeter.

I promise to be good.

Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

Dont guess you could draw me a detailed diagram. It would be greatly appreciated,mexicang

Your killing me here. I suck at paint, but I gave it a shot. The WHITE/ blue comes from the 561T, you need to program the 561T to use this wire as defroster wire that activates 10seconds after the RS engages. The shutdown wire comes from the car, you have to tag this for the 561T anyways. You will need to tap into the ribbon cable and tie the isolated outputs into the pink and orange wires in the ribbon harness. You will also need to tie an isolated output for any additional relays you use to power acc2, ign2, ign3, etc into the -activation input on the relays. Certified Security Specialist

Always check info with a digital multimeter.

I promise to be good.

Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

You have been a great help. Not many people are willing to help. Thanks. Do you know how to make a vehicle stay running when the key is removed, and die when the brake is pressed. Emergency vehicles use this feature. If im asking to many questions let me know.mexicang