Remote Start turns off after couple sec

Hi!

I was installing MOTORJOY GTO-PATROL security alarm and remote start on my '00 Dodge Neon SE, everything on the alarm works fine, but the problem is the remote start.

 I wired everything, hand brake, brake switch and Ignitions, when i try remote strat the car cranks and the engine fires fine, runs good for a couple seconds and then shut down.

 I try whit the BLACK/ Gray TACH signal on the DIS and does this, then try the GREEN / WHITE 12V for DIS and does same problem (even if disconnect the 12V input for Remote Start do this fail).

I made this test: If i release the hand brake or open the hood the remote start not even crank, so this inputs are fine.

 I guess the problem is the 12V input for remote start when the car is running, i migth be using the wrong cable.

 Could somebody help me out i have this NEON all striped and dont want drive that way.

2000 Dodge Neon Security Information:

Constant   12V+ Pink/Black or Red  Ignition Switch Harness  Starter    Yellow                  Ignition Switch Harness  Ignition   Dark Blue                Ignition Switch Harness  Ignition 2 BLACK/ Orange             Ignition Switch Harness  Accessory  BLACK/ Orange            Ignition Switch Harness (Heat/AC)  Tach       BLACK/ Gray              Coil

This is the Alarm Installation diagram, if you cannot see the link, please copy and paste on adress bar:

Thank you in advance for all your info.

grey key or black key?

grey key, iguess this is for Sentry systems, i there any way to bypass the sentry module ? Man i sad, i spen half of my paycheck on this and its not for my car.

R U using a By Pass Kit?If not...........You need a ByPass kit..........Either a Hide a Key type or a Programmable typeMO

Don't Learn from Others Mistakes

You Might Be the One That Knows.