Wiring 2 DVC 4 Ohm Subs

Home / the12volt's Install Bay / Car Audio / Wiring 2 DVC 4 Ohm Subs (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

blade13432

Member - Posts: 5

Joined: March 27, 2005

Posted: May 10, 2005 at 7:27 PM / IP Logged

How would I go about wiring up two 4 ohm DVC Alpine Type R's subs to a Alpine Mono Block amp?

Back to Top

racer427

Silver - Posts: 381

Joined: August 04, 2004

Location: United States

Posted: May 10, 2005 at 7:33 PM / IP Logged

Here ya go. Hope this helps.

Chris

	Wiring Option #1
	Wiring Option #2

Speaker Polarity
Positive (+)	Negative (-)
red post	black post
purple dot - 4 ohm	no dot
red dot - 8 ohm	no dot

Alpine CDA-9833 HU

Diamond Audio M661 Components

MTX Thunder T6.6 Components:rear fill:

Cadence Q400 4 Channel Mains + rears

Thunder 801D Subs

MTX 1004 10's

Dual 4g wire to rear

4g grounds

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Wiring 2 DVC 4 Ohm Subs

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.