the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2001 Ford F-150 SuperCrew Alarm/Remote Start Wiring


Post ReplyPost New Topic
< Prev Topic Next Topic >
Stimpy 
Member - Posts: 1
Member spacespace
Joined: June 12, 2005
Location: United States
Posted: June 15, 2005 at 3:46 PM / IP Logged  
I am looking at installing a Viper 791 into my 2001 SuperCrew. Does anyone have a wiring diagram for this truck? Any suggestions or recommendations in regards to the install.
Thanks
chungo 
Copper - Posts: 135
Copper spacespace
Joined: December 31, 2003
Location: United States
Posted: June 15, 2005 at 4:10 PM / IP Logged  
 FORD / F SERIES LIGHT DUTY / 2001 / Remote Start
[PRINT THIS PAGE]
12volts yellow and lt. GREEN/ purple  +  ignition harness
Starter RED / lt. blue  +  ignition harness
Second Starter     
Ignition dk. blue/lt. green  +  ignition harness
Second Ignition gray / YELLOW  +  ignition harness
Third Ignition lt. blue/pink  +  ignition harness
Notes: Power this wire if vehicle is equiped with only rear anti-lock brakes. Vehicles with all wheel anti-lock brakes do not have this wire.
Accessory RED / black  +  ignition harness
Second Accessory BLACK/ green  +  ignition harness
Keysense     
Power Lock pink / YELLOW    passenger kick, door harness
Notes: Negative pulse, type B, on keyless entry models. Five wire, type C, on non-keyless models, mastered from the driver switch.
Power Unlock pink/green    passenger kick, door harness
Notes: The GEM in this vehicle shuts down after the doors have been locked for a certain time period, to wake-up the system refer to directfax document #1093.
Lock Motor pink/black  5wi driver kick, door harness
Unlock Motor RED / orange  5wi driver kick, door harness
Parking Lights+ brown  +  headlight switch
Notes: May also be found at trailer connector next to diagnostic connector under dash.
Parking Lights- lt. GREEN/ YELLOW  -  headlight switch
Notes: If equipped with autolamps.
Hazards     
Turn Signal(L)     
Turn Signal(R)     
Reverse Light     
Door Trigger BLACK/ yel (L), BLACK/ pink (R)  -  see notes
Notes: The BLACK / YELLOW catches the drivers door and the BLACK/ pink catches the passengers door. The wires are found in their respective door harnesses. On the Super Crew the rear door trigger is BLACK/ lt. blue low in the driver kick panel. Use all wires and diode isolate each. See DirectFax document 1076 for wiring information. Both wires may also be found at the GEM module located above the fuse box. On models without a dome light delay use ORANGE / lt. green (-) at the light switch.
Dome Supervision BLACK/ lt. blue  +  passenger kick panel
Trunk/Hatch Pin     
Hood Pin     
Trunk/Hatch Release     
Power Sliding Door     
Factory Alarm Arm     
Notes: Arms when locked with the door open. To simulate, send a negative trigger to the lt. blue/white wire at the RAP module, located behind the light switch, while locking.
Factory Alarm Disarm dk. GREEN/ purple  -  driver kick, door harness
Disarm No Unlock     
Tachometer     
Notes: Tach wire: on the 4.2L it is a dk. blue/lt. green at the coil pack on top of the motor. On the 4.6L go to any of the 8 ignition coils and use the wire that is not RED / green. On the 5.4L it is a lt. GREEN / WHITE at the coil on the passenger side of the motor between the fuel injectors.
Wait to start     
Brake Wire lt. green  +  brake pedal switch
Notes: May also be found at trailer connector next to diagnostic connector under dash.
Parking Brake     
Horn Trigger dk. blue  -  horn switch
Memory Seat 1     
Memory Seat 2     
Memory Seat 3     
2001 Ford F-150 SuperCrew Alarm/Remote Start Wiring -- posted image.
Interface Module:Category:
Immobilizer Bypass
Required:
Yes
Type:
PATS
Part #: 555PW
Alternate Part1 #: 555FW
Alternate Part2 #: 556UW
Alternate Part3 #: 555U
Notes:
2001 Ford F-150 SuperCrew Alarm/Remote Start Wiring -- posted image.      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, April 18, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer