the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2003 GMC Sierra Door Trigger


Post ReplyPost New Topic
< Prev Topic Next Topic >
mcloop 
Member - Posts: 11
Member spacespace
Joined: January 10, 2004
Location: United States
Posted: June 19, 2005 at 11:25 PM / IP Logged  

I need one wire for both doors. Everything else works fine. Alarm/RS.

I must have missed something on that one wire.

Any help?

dare_ds69 
Silver - Posts: 419
Silver spacespace
Joined: January 25, 2005
Location: New Jersey, United States
Posted: June 20, 2005 at 6:35 AM / IP Logged  
Door Trigger gray/blk (L), BLACK/ wht (R)  -  each door module in each door
Notes: On base model trucks the door trigger wires are in the lt. blue plug at the BCM, pins B4 and A5. On 4dr trucks the LR door trigger is lt. blue/black, pin A3, and the RR is lt. GREEN/ black, pin A2. They are in the purple plug at the BCM. Use all wires and diode isolate.
The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back.
how own your mind, control your life.
MECP certified. always use a DMM
mcloop 
Member - Posts: 11
Member spacespace
Joined: January 10, 2004
Location: United States
Posted: June 20, 2005 at 12:01 PM / IP Logged  

I need a positive trigger for the door(s). One that isn't tied to the dome light circuit. The 456G module that I'm using for the locks and the door trigger say to use the under dash light, but I don't have one.

I want to utilize the active re-arm feature of my alarm/RS. Basically if a door isn't opened within 30 seconds, it will re-arm itself in case it was accidental. If I tie to the dome light circuit, it defeats the purpose because it lights when unarming anyway (like a door was opened).

Do you know of a positive door trigger for this truck?  2003 GMC Sierra.

Thanks in advance, even if you don't.

Mike

gus1 
Gold - Posts: 1,013
Gold spacespace
Joined: October 15, 2003
Location: Canada
Posted: June 20, 2005 at 1:56 PM / IP Logged  
There will be a positive door trigger..... grey/black in the harness that runs up the driver's side A-pillar. You can also find it at the driver's side fusebox on the end of the dash, where the harness that runs up the A pillar is connected.
HTH
Gus
Wherever I go, that is where I end up......
JWorm 
Platinum - Posts: 2,208
Platinum spacespace
Joined: December 11, 2002
Location: New Hampshire, United States
Posted: June 21, 2005 at 12:01 AM / IP Logged  
There is no positive door trigger wire that doesn't read the domelight turning on. You need to run a wire into each of the front doors. The rear doors (if it has any) can be found at the bcm. Each individual trigger will be negative and you'll need to isolate them with diodes.
mcloop 
Member - Posts: 11
Member spacespace
Joined: January 10, 2004
Location: United States
Posted: June 21, 2005 at 9:06 AM / IP Logged  
Thanks. That's a downside to the 456G module. It has a neg trigger out but not during domelight super.
Autoobsession 
Copper - Posts: 119
Copper spacespace
Joined: April 29, 2004
Location: United States
Posted: June 21, 2005 at 9:25 AM / IP Logged  
There is a positive trigger in the domelight in the upper center console.
mcloop 
Member - Posts: 11
Member spacespace
Joined: January 10, 2004
Location: United States
Posted: June 21, 2005 at 9:34 AM / IP Logged  

AO,

Is it tied to the dome light and remains hot while the light is on or is it "off" when the door closes? It needs be door open = 12V and door closed = 0V

Thanks,

Mike


Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Wednesday, May 15, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer