tech wire for Toyota camry

Home / the12volt's Install Bay / Car Security and Convenience / tech wire for Toyota camry (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

oasis475

Member - Posts: 25

Joined: January 28, 2003

Location: United States

Posted: July 10, 2005 at 3:17 PM / IP Logged

hey, i am trying to install valet 562t and i just wanted to know the Location of the TECH wire in 1995 camry I4.

also "Orange(ground when armed output)" wires -- should i just ground this wire??

and

WHITE/ Blue(- activation input) --- this goes into the valet switch right?

349517

Member - Posts: 38

Joined: April 03, 2005

Location: United States

Posted: July 10, 2005 at 6:17 PM / IP Logged

12volts	white - WHITE/ red	+	ignition harness
Starter	BLACK/ white	+	ignition harness
Second Starter
Ignition	BLACK / YELLOW	+	ignition harness
Second Ignition	BLACK/ orange	+	ignition harness
Third Ignition
Accessory	pink/blue	+	ignition harness
Notes: Not required for remote start.
Second Accessory
Keysense
Power Lock	blue/white	-	passengers kick blue plug
Power Unlock	lt. GREEN/ red	-	passengers kick blue plug
Lock Motor
Unlock Motor
Parking Lights+	green		bottom of fuse box
Notes: In a white connector just below the fuses with the wires exiting out toward you.
Parking Lights-	green		steering column
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger	RED / white	-
Notes: Remove black plastic air duct covering the top right side of the fuse box to access a 6 pin plug containing the RED / white.
Dome Supervision
Trunk/Hatch Pin	RED / white	-	light or sw. in trunk
Notes: Tied in with the door trigger on the wagon models.
Hood Pin
Trunk/Hatch Release
Power Sliding Door
Factory Alarm Arm
Factory Alarm Disarm
Disarm No Unlock
Tachometer	black	AC	check connector
Notes: Located on the rear side of the passenger strut tower.
Wait to start
Brake Wire	GREEN / WHITE	+	bottom of fuse box
Notes: In a white connector just below the fuses with the wires exiting out toward you.
Parking Brake
Horn Trigger	GREEN/ black	-	steering column
Memory Seat 1
Memory Seat 2
Memory Seat 3

Interface Module:	Category: Immobilizer Bypass	Required: No	Type: N/A
Part #: N/A
Notes:

tech wire for Toyota camry - Last Post -- posted image.

This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.

Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.

Jim

Best Buy MECP Mobile supervisor in store 820

jimmyb3rddegree@hotmail.com

genehewett

Copper - Posts: 151

Joined: December 12, 2003

Location: Georgia, United States

Posted: July 10, 2005 at 6:33 PM / IP Logged

Do you mean Tach? Before you start installing this system you need to understand a few things. If you have not installed a remote start system this is a good first timer "if you have a good amount of security install experiance". It is pretty much stright forward and you wont need anything special like an imobileizer by pass. Good Luck.

Do not ground the orange wire. This is used to control things like starter kill, scanning LEDs, or other things that need to be turned on when the system is armed and off when its disarmed.

TOYOTA, CAMRY, 1995, Tachometer: This wire is AC voltage. The color is Black at the following location.

On the 4 cylinder motor the black wire is at the check connector located on the rear side of the passenger strut tower. On the 6 cylinder the black wire is at the ignitor located on the drivers side strut tower.

genehewett

Copper - Posts: 151

Joined: December 12, 2003

Location: Georgia, United States

Posted: July 10, 2005 at 7:23 PM / IP Logged

Thats right. Sorry for that mistake. Thanks.

KarTuneMan

Platinum - Posts: 7,056

This member has made a donation to the12volt.com. Click here for more info.

This member consistently provides reliable information

Joined: December 14, 2004

Location: Isle Of Man

Posted: July 10, 2005 at 8:17 PM / IP Logged

Welcome to the world of DEI.....where every install manual is written for someone who has ALLREADY INSTALLED a couple hundered units.....

status output, activation input............see what I mean ?

oasis475

Member - Posts: 25

Joined: January 28, 2003

Location: United States

Posted: July 10, 2005 at 8:46 PM / IP Logged

thank you much for the info.. i found the wire

Just another quick question

valet 562t has a feature that i can control the parking lights polarity. Can i just hook up the (+) parking lights with the Green wire(+) under the fuse box??

In the manual its says that toyota are (-) parking lights... this is little confusing..

genehewett

Copper - Posts: 151

Joined: December 12, 2003

Location: Georgia, United States

Posted: July 10, 2005 at 8:53 PM / IP Logged

Yes just leave the jumper like it came from the factory and it will output 12v.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

tech wire for Toyota camry

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.