How to wire a 2 amp system

Home / the12volt's Install Bay / General Discussion / How to wire a 2 amp system (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

lauvers

Member - Posts: 1

Joined: May 04, 2002

Location: United States

Posted: May 04, 2002 at 11:09 PM / IP Logged

I have

a sony xm-2100g xplod amp and a Punch 100 amp,

2- 12" xplode swubs 2 xplode 6x9 2 xplode 5" speakers

Can anybody recommend the best way to wire this system?

Coaches Corner

BIGProbe

Member - Posts: 1

Joined: May 06, 2002

Location: United States

Posted: May 06, 2002 at 11:17 AM / IP Logged

What are the specs for the amps?

NyxBass

Silver - Posts: 226

Joined: March 14, 2002

Location: United States

Posted: May 07, 2002 at 7:06 PM / IP Logged

From what I can tell, the sony is a 100x2 amp, and the punch a 25x2. I would run the Sony for the subs, bridged into a 2 ohm load. I would run the front speakers off of the Punch, and the rear speakers off the head. That should use your power the best way possible.

/NyxBass

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

How to wire a 2 amp system

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.