Can't figure out door locks!

OK, will do.

Hook up as described by you, manual, other? Just want to clarify.

Also, "not used" means Ground according to DEI?

Thanks,

Owen

NOT USED means NOT USED!!!!!  Tape up and Harness up....... MO

Don't Learn from Others Mistakes

You Might Be the One That Knows.

Forgive me, but doesn't that contradict what you posted earlier regarding grounding them? ----------------------------------------- WHITE / Black = GROUND GREEN / Black = Lock wire on Acuator VIOLET / Black = 12 volt Constant ( + ) BROWN / Black = GROUND BLUE / Black = UNLock Wire on Actuator VIOLET = 12 volt Constant ( + ) ---------------------------- Well, no time to work on it tonite, it'll have to be tomorrow nite. Thanks again to everyone and wish me luck! Owen

The contradiction is in how you are reading it............

The actuator wires only go to the wires I have listed from your Viper 800 plug.The GROUND only goes to the wires I have listed from your Viper 800.The Constant 12 volts ( + ) only goes to the wires I have listed from your Viper 800.

When the Lock / Unlock on the Remote is pushed, it will alternate the Ground thru the On-Board Relays

WHITE / Black = GROUND

GREEN / Black = Lock wire on Acuator VIOLET / Black = 12 volt Constant ( + ) BROWN / Black = GROUND BLUE / Black = UNLock Wire on Actuator VIOLET = 12 volt Constant ( + )

MO

Don't Learn from Others Mistakes

You Might Be the One That Knows.

I'm an idiot cuz I still don't see it, I guess that's what pro installers are for. Anyway, I'll try it tomorrow and let you know. Thanks, Owen

Success! Thanks to you all for your help, this place rocks! I still don't see how "taped up and harnessed up" mean the same as "grounded", but what I did was infact ground the BRN/WHT and WHT/BLK wires. Thanks again. Now on to my next post :-) Owen