Omega Max E

diode isolation??

well the drivers door and the 3 other doors are on seperate wires...but for some reason the trigger to the drivers door doesn't light up the domelight...so I just hooked the other doors to the alarm...I think I had the smart trigger port connected and that was causing a false alarm

I am having an issue with my Omega Max remote start/car alarm. I really hope you huys can help. I recently programmed the echo 2 transciever to the unit following the steps in the instruction manual. The Echo 2 did not work properly because there is something that plugs into the omega unit for the echo 2 to work correctly, which I did not have. I then reprogrammed the original transmitter back to the omega max and since then, my remote start does not work. I can activate the remote start via transciever, the engine will crank run for 3 seconds, then engine kills, and the omega will restsart the engine allowing this process to continue until I terminate the remote start via transceiver. why is it doing this ?? if you need more information please let me knowThanks

sounds like you have more than one ignition or accessories wire...my crown vic was doing the samething into I found the second ignition wire and ran a relay from the satellite ports

oh yeah what kind of car is it?

if you dont have it worjked out yet, e-mail me and i will help walk you through the set-up that you have.... sounds like the problem is in the install and not the unit.....Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt