the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

97 F150 and Autostart Alarm


Post ReplyPost New Topic
< Prev Topic Next Topic >
Sierra2700 
Copper - Posts: 117
Copper spacespace
Joined: October 08, 2004
Posted: September 09, 2005 at 2:01 PM / IP Logged  

Just installed an autostart 2 way alarm system. Problem being, when I get into the truck and begin to drive it the shock sensor will go and the alarm will go off.

The remote start and door locks work fine. The only problem is if you start the vehicle and then open or close a door, or if you tap on the shock sensor (or just shake the car really hard) the alarm will still go off(while the car is running).

I was told that the autostart's use the powered up ignition wire to disable the "alarm" portion of the remote starter. Not sure if this is true or not but it shouldn't matter because the ignition wire is being powered up when I remote start.

Any help anyone?

thepencil 
Gold - Posts: 1,526
Gold spacespace
Joined: December 16, 2002
Location: Canada
Posted: September 09, 2005 at 3:38 PM / IP Logged  
The default is set on Passive Arming.
You will need to make the change to Active Arming instead.
Once disarm with the remote and it see the ignition wire power up I don't see why it will sound the alarm. Remove the shock sensor all together and see if the problem continue.    
Be careful whose advice you buy, but be patient with those who supply it.97 F150 and Autostart Alarm - Last Post -- posted image.
blazeronspokes 
Copper - Posts: 102
Copper spacespace
Joined: February 09, 2005
Location: United States
Posted: September 09, 2005 at 5:11 PM / IP Logged  
check and make sure that the yellow 12v ignition input on the actual alarm brain is hooked up. it may have an ignition output on the remote start harness and an ignition input on the alarm harness.
Sierra2700 
Copper - Posts: 117
Copper spacespace
Joined: October 08, 2004
Posted: November 03, 2005 at 6:25 PM / IP Logged  
How do you switch between Active and Passive arming? The manual doesn't seem to say how.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Tuesday, February 27, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer