556u remote start problem on acura 01 RL

I have a 556U. I tried to connect in every way and it still doesn't remote start the car. Red to 12v+, black to ground, blue to remote starter wire on the alarm. What i suspect is that the BLUE wire. I think my connection is wrong because it needs to read ground output during remote start. I have the AsianWolf 8000RS. One of the wire is BLUE/ORANGE said to be  Remote Starter Output(-)500mA. Is it the one that i should connect it to instead of the starter off the alarm system which is violet. Do I need to use any other wires for this specific car or just the three above. Any hint would be appricated.

nope that will be the wrong wire

you either need the ground out when running wire, or the satus ouput wire, both are negative pulse

I am going to take a shot in the dark here

the 556u is a bypass for that car?.....so i see it like this, powerup the red wire to 12 volts and the black wire to ground when running(blue/orange)

leave the blue wire from the 556u alone

no, don't do that

red goes to constant power

black goes to ground

and blue goes to the status wire or ground out when running wire from the alarm brain

This is what i was told when I bought the alarm system from the dealer. What other bypass would you recommend. The BLUE/ORANGE HAS NOT BEEN CONNECTED TO ANYTHING YET. WHY WOULD YOU LEAVE THE BLUE WIRE FROM THE 556U ALONE. The system is fully functional but remote starter.

do this like I said in my last post

no, don't do that

red goes to constant power

black goes to ground

and blue goes to the status wire or ground out when running wire from the alarm brain

what alarm is it

if you look in the install manual, find a wire that says (-) status out or (-) ground out when running

connect the blue wire from the bypass one of those

you can try this