Clifford remote start Programming problem

Acura integra 2001, clifford G5 solaris 5

I try to program the RPM for my remote start, with the plan view 2 valet switch

I go in the menu installer, a push 3 time on the black button, I heard 3 chirp

after a push 1 time on the stars button, I heard 1 chirp

after I push one time on  arm/disarm, and the led don't flash, it stay on all the time

the car is running at 850 rpm

I am doing someting wrong ?

or the cliffnet wisard wire beetween the 2 box is not good ?I did a extension it was to short

I forget someting

when  the engine is running a push  the star on the remoter  for remote start

I remove the key, the car stil run

I go out of the car

I arm the system, and the car is running, and the alarm is on, the led is flashing,

to stop the car I disarm , and I need to push on the brake or I push down the E brake

thank a lote

it begin to be cool here

sorry for confusion, my english is bad

I want to mean,

I am not able to program my alarm

the car is running great

I just intall the alarm,  and I can't program the rpm

yes I am sure, I hear three chirps

When I need to push on the arm and desarm button on the remote to enter the RPM, does I need to hold it ??

if the rpm input is wrong wire

it supose to flash one time

but it does not flash at all

And last night a arm my alarm, and this morning, it was desarm

my module is **** ?brand new clifford module ****

is that possible ??

sorry

broken module

sorry

broken module

is that commun thing on clifford ??

the wire beetween the two module for data communication, I did a extension because it was to short, is that causing probleme??