2005 chevy avalanche, audiovox AX901

Home / the12volt's Install Bay / Car Security and Convenience / 2005 chevy avalanche, audiovox AX901 (

Topic Closed)

Welcome Guest :)

Members

Next Page > < Prev Topic Next Topic >

05gt

Silver - Posts: 628

Joined: October 30, 2005

Location: British Columbia, Canada

Posted: November 26, 2005 at 6:30 PM / IP Logged

I am installing a audiovox AX901 into this vehicle, I haven't hooked the bypass up yet , I try to remote start with the key in the ignition and it starts but immediately dies

also the air bag light has come on even when I start the vehicle with the key

ignition 2 off of the alarm brain is hooked up to the white wire in the vehicle, which is ignition 2

someone please help cause customer will be here at 6 pacific time to pick vehicle up

mo12v

Platinum - Nominee - Posts: 2,748

This member consistently provides reliable information

Joined: September 30, 2003

Location: Afghanistan

Posted: November 26, 2005 at 7:26 PM / IP Logged

You need to Power up all 3 Ignitions...

You should hook up your ByPass prior to Remote Start also

Constant 12 volts	RED & RED / WHITE	IGNITION SWITCH HARNESS
Ignition 12 volts	PINK	IGNITION SWITCH HARNESS
Starter	YELLOW	IGNITION SWITCH HARNESS
Dome Light	GREY/BLACK (+)	AT BCM *
Trunk Pin Switch	N/A
Parking Lamp	GREY/BLACK (-)	AT MAIN SWITCH
Power Lock	GREY	IN EACH DOOR DUE TO #205
Power Unlock	TAN	MULTIPLEXING **

* BCM Located Below Steering Column ** Reversal Rest At Nothing Door Locks

Click Here For Our Databus & Immobilizer Bypass Cross Reference

Accessories
Window Up	D\ BLUE P\ BLUE D\BLUE P\BLUE @ Each Switch Due To Data Link
Window Down	F/ BROWN F/ BROWN R/BROWN R/BROWN
Ign Key Warn	LIGHT GREEN (-)	IGNITION SWITCH HARNESS
Trunk Release	N/A
OEM Horn	BLACK (-)	STEERING COLUMN HARNESS
Headlights	WHITE (-)	AT HEAD LIGHT SWITCH
OEM Alarm Arm
OEM Alarm Disarm	LT GREEN (-)	IN PASS KICK PANEL

Reversal Rest At Ground Type Window Circuit Wiring

OEM Hood Pin Wire Is PINK/BLACK @ Switch On Top Of Radiator Support

Remote Start
Tach Signal	WHITE	AT PCM *
Ignition #2	WHITE	IGNITION SWITCH HARNESS
Ignition #3	ORANGE	IGNITION SWITCH HARNESS
Accessory	BROWN	IGNITION SWITCH HARNESS
Neutral Safety	WHITE (-)	PCM CONN C3 PIN #13 *
Brake Light	WHITE (+)	AT SWITCH ABOVE BRAKE PEDAL
Reverse Light	LIGHT GREEN (+)	EITHER TAIL LT ASSY OR TRAILER CONN**
Rear Window Defrost	N/A

*PCM Located On The Drivers Side Of The Motor. Tach Wire Is In The BLUE Conn (C1) Closest To The Firewall,Pin #49. Also Found Back Of Cluster in 24 pin GREY Conn Pin # A12 ** Also Found At BCM In 6 Pin Black Connector

G.M. Passlock II Bypass

Don't Learn from Others Mistakes

You Might Be the One That Knows.

cntrylvr79

Silver - Posts: 582

Joined: July 02, 2005

Location: United States

Posted: November 26, 2005 at 7:29 PM / IP Logged

You'll have to hook the bypass up before the truck will remote start. Just putting the key in the ignition will not do it the code is generated when the key is turned to the crank position. The airbag light should assuming nothing got cut or disconnected shut off about 7 seconds after the vehicle starts running. Good luck

Cause I'm So white and nerdy...

First Class Certi-fried installer

05gt

Silver - Posts: 628

Joined: October 30, 2005

Location: British Columbia, Canada

Posted: November 26, 2005 at 9:27 PM / IP Logged

mo12v, at the time when I posted this I had taken the bypass out to see if it was the issue, I did have it in prior and I tried remote starting but when no luck, then I took it out

Didn't know it had 3 ignition wires, every possible website I checked (4 of them) said it had 2 ignition wires and 2 accessory wires, I even triple tested

I am guessing that is why the airbag light is on, cause I didn't hook up ignition 3

just out of curiousity where did you get the info you posted earlier

mo12v

Platinum - Nominee - Posts: 2,748

Joined: September 30, 2003

Location: Afghanistan

Posted: November 26, 2005 at 9:59 PM / IP Logged

Personal DATA , & OMEGA......

The ORANGE wire is not Airbag

That is how i power up these wires..........

Make sure you have evrything ready & Installed prior to ByPass Programming

Don't Learn from Others Mistakes

You Might Be the One That Knows.

05gt

Silver - Posts: 628

Joined: October 30, 2005

Location: British Columbia, Canada

Posted: November 26, 2005 at 10:07 PM / IP Logged

just want to make this clear, the vehicle has 3? ignition wires, and 1 accessory wire?

so the third ignition wire in the vehicle is Orange, and has to be powered as third ignition?

I didn't mention that when I go to remote start the vehicle it trys to start and it does, but right away it shuts itelf down

this is how I had it

pink (1st ignition) to pink in the vehicle, pink/white (2nd ignition) to white in the vehicle, orange (1st accessory) to orange in the vehicle, and I did have ORANGE / white (2nd accessory) to brown in the vehicle, when I had it like this it wouldn't do anything

I cut the ORANGE / white wire from the brown and it was able to start but then immediately die, that is as far as I got

anickle

Member - Posts: 42

Joined: August 01, 2004

Location: Canada

Posted: November 27, 2005 at 1:13 AM / IP Logged

I have always had luck with the orange as an acc, where do you have the passlock module grounded to? passlock ground in the column has not always worked for me in newer gm's and chev's so i ground them right to the kick. good luck

andrew nickle

05gt

Silver - Posts: 628

Joined: October 30, 2005

Location: British Columbia, Canada

Posted: November 27, 2005 at 1:18 AM / IP Logged

the passlock ground is going to the black passlock wire up at the ignition switch

what do u mean in the kick panel

anickle

Member - Posts: 42

Joined: August 01, 2004

Location: Canada

Posted: November 27, 2005 at 1:21 AM / IP Logged

sorry i mean i ground it to the body in the kick panel, or the fire wall if thats easier for you

andrew nickle

05gt

Silver - Posts: 628

Joined: October 30, 2005

Location: British Columbia, Canada

Posted: November 27, 2005 at 1:26 AM / IP Logged

Well I will try something along those lines when I get the customers car back

I always thought the black off of the module goes to the passlock ground from the ignition

didn't know you could just ground it anywhere

Do you have any info on the ignition wires and why maybe the airbag light is on

Next Page >

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.