Power Lock Motor Lock?

Home / the12volt's Install Bay / Car Security and Convenience / Power Lock Motor Lock? (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

tintman97

Copper - Posts: 113

Joined: October 20, 2005

Posted: December 08, 2005 at 2:32 PM / IP Logged

What is the diffrence? also doing a 98 maxima double pulse unlock i know but when we test the wires there is no drop in voltage when we hit the lock or unlock stays the same? These are negitive pulse so it should show 12 volts all the time till the switch gets hit. This does absolutly nothing? Any ideas

Snapper

Back to Top

guatemalanboy

Member - Posts: 18

Joined: February 07, 2005

Location: United States

Posted: December 08, 2005 at 2:51 PM / IP Logged

hey tintman have fun hope this helps u out and to answer your question power lock will rest at ground and do 12 volt when switch is hit, lock will do ground if the switch is hit if its (-) or do (+) if the switch is hit

12volts	wht/red - wht/pur	+	ignition harness
Notes: The ignition harness wires change color at a plug. The above listed colors show both sides of the plug.
Starter	blk/yel - blk/wht	+	ignition harness
Notes: The ignition harness wires change color at a plug. The above listed colors show both sides of the plug.
Second Starter	grn/blk - RED / blu	+	ignition harness
Notes: The ignition harness wires change color at a plug. The above listed colors show both sides of the plug.
Ignition	blk/wht - blk/red	+	ignition harness
Notes: The ignition harness wires change color at a plug. The above listed colors show both sides of the plug.
Second Ignition
Third Ignition
Accessory	RED / yel - red	+	ignition harness
Notes: The ignition harness wires change color at a plug. The above listed colors show both sides of the plug.
Second Accessory	blue - wht/blu	+	ignition harness
Notes: The ignition harness wires change color at a plug. The above listed colors show both sides of the plug.
Keysense
Power Lock	lt. GREEN/ red	-	in drivers door at switch
Power Unlock	GREEN/ YELLOW	-	in drivers door at switch
Notes: Requires a double pulse.
Lock Motor	BROWN / white		in drivers door at switch
Unlock Motor	brown		in drivers door at switch
Parking Lights+	RED / green		steering column
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger	RED / white	-	low in drivers kick
Dome Supervision
Trunk/Hatch Pin	purple / YELLOW	-	drivers kick or BCM
Notes: The BCM (body control module) is located just below the radio.
Hood Pin	yellow/black	-	BCM
Notes: The BCM (body control module) is located just below the radio.
Trunk/Hatch Release	purple / YELLOW	-	low drivers kick
Notes: Must use a relay to interface with this circuit.
Power Sliding Door
Factory Alarm Arm	arms w/ lock
Factory Alarm Disarm	disarms w/ unlock
Disarm No Unlock
Notes: A single negative pulse to the unlock wire will disarm without unlocking.
Tachometer	WHITE/ green	ac	ECM
Notes: The ECM is located in the front of the center console on the transmission hump. The wiring is easily reached by removing the small black panel just to the front of the center console on the passenger side. the wire is in the middle row, 7th one in from the left.
Wait to start
Brake Wire	RED / green	+	at brake switch
Parking Brake
Horn Trigger	GREEN / WHITE	-
Memory Seat 1
Memory Seat 2
Memory Seat 3

Interface Module:	Category: Immobilizer Bypass	Required: No	Type: N/A
Part #: N/A
Notes:

100%Guatemalan

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Power Lock Motor Lock?

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.